Electronics Forum | Thu Feb 15 08:00:35 EST 2018 | cbart
Hi many thanks for your help, I mean reflow > oven. Ok, yes, it sounds like the debris that builds up on fans/heaters/ducting may be making its way onto you product. if the exhaust fan that vents your machine failed this could be the cause, or it
Electronics Forum | Thu Aug 25 13:06:45 EDT 2005 | carln
I evaluated a couple of the Vigon products by Zestron last year and I think the SC200 was one of them. They seemed to clean OK, and Zestron said they were biodegradable, but they conveniently failed to disclose that they contained VOCs. If you are
Electronics Forum | Mon Sep 01 04:55:20 EDT 2008 | benefon
Hello all Our Omni 5 has given the 'Cooling module high temp' warning twice during the past month. I suspect that the blower motor is the culprit but have not been able to verify this because the oven has started up normally after acknowledging the
Electronics Forum | Wed Jan 15 11:18:51 EST 2020 | avillaro2020
Hi Evtimov, Thanks again! The solder wicking/open solder joint is not actually gross rejection, it is only a few and appeared random (difficult to trend the location of the opens), what is perflexing is that i have this 1 or 2 open solder joints sur
Electronics Forum | Tue Jan 22 20:32:08 EST 2002 | davef
Oooo, thanks for the conversion. Being metrically challenged, az a skratchin ma haid thar fer a mite. We do a G-10 160 thou and have similar issues. Now, we�ve talked about barrel fill [ie, slowing belt speed, increasing pre-heat temps, etc] befor
| 1 |
