Electronics Forum | Tue May 30 09:53:43 EDT 2000 | Neil Peaslee
Right now we are using a custom built web email solution to provide SMTnet web email. Unfortunately the service agreement recently expired and I have to keep a fairly close eye on it to make sure that it is running. Within the next few weeks we will
Electronics Forum | Thu Jan 05 08:53:21 EST 2023 | tommy_magyar
Check manufacturing date code (if you can) on the reels against your receipt of the material. If you are a contract manufacturer you could make a supplier quality claim if they have sent you expired components (and you did not know). A relatively eas
Electronics Forum | Thu Mar 16 22:19:38 EDT 2017 | deanm
First, reflow does not reset the clock for MSL exposure. The best solution is to run the second side before the exposure time expires. I am curious to know why they must sit for 40 hours. If that cannot be done, then store the assemblies in a dry c
Electronics Forum | Tue Dec 12 19:57:56 EST 2017 | myke03o
Hi Experts. We have an expired OSP pcb and we wanted to extend the shelp life. Is it possible to rework the PCB by removing the OSP coating, micro etching and re-applying OSP finish. Any advice if this can be done? Any solution for this OSP pcb e
Electronics Forum | Thu Aug 21 16:33:49 EDT 2008 | decaire
The 2 most common approaches for MSD Tracking and Control on the factory floor are: 1) Manual paper-based procedures (Example: Log Sheet or Label that the operator must fill out and pay attention to) - or - 2) Software-based tracking system (Example
Electronics Forum | Wed Aug 01 11:22:25 EDT 2012 | davemac62
ERROR: "The specified i/o operation on DeviceHarddisk0Partition01 was not completed before the timeout period expired" This is followed by out of control conveyor speed and zone temps. Oven recovers when the error is acknowledged. This is happenin
Electronics Forum | Fri Mar 26 09:00:19 EDT 2010 | krish_bala
Thank you Graham for the response. The particular BGA that we currently Bake is a Level 3 BGA, which means the BGA will expire in 7 days after removal. We are currently baking the BGAs once a week for the problem described above. These devices are u
1 |