Electronics Forum | Thu May 21 02:11:12 EDT 2015 | Pawel
Hi everyone, I have a lot off failed inspections on SPI with contaminated PCB (hair, speck of dirt, fiber...). Do you know any vacum tool which can clean board before screen printer?
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Mon Oct 14 11:56:02 EDT 2024 | poly
I just got a used SE500 Ultra and the machine appears to move in the X and Y, conveyor belts and width. It however fails to home. I assume the end sensor has physically moved or it's an issue with the Z axis. The logging says it's axis 0, however th
Electronics Forum | Fri Jul 18 16:04:31 EDT 2014 | comatose
We had this. The anti-backlash nuts were binding. We took them apart, chased the threads with a tap and re-assembled with slightly less pre-load. Hasn't been a problem since.
Electronics Forum | Tue Oct 15 11:15:16 EDT 2024 | poly
It's Z! The Z hall effect sensor connector was broken but it was easy to solder on a new one. I however can't work out how to change conveyor direction, as the directions for updating it in the manual don't appear to work.
Electronics Forum | Fri Oct 25 15:31:27 EDT 2024 | stevea
For assistance to all your CyberOptics support needs, Contact ASC International. http://www.ascinternational.com or 763-479-6210. Thank you. Steve Arneson
Electronics Forum | Fri Nov 22 14:33:27 EST 2024 | carl_p
For the Conv direction. Depending on the software version your at - It should just be an option in within the on screen settings to set direction of travel or "ping pong"
Electronics Forum | Thu May 21 03:09:36 EDT 2015 | dinhhuunam
Hi Pawel, Before Printer using Vacuum & Cleaning Loader have Cleanning unit - Removing dust with Roll brush -get rid of smallest dust with low noise and strong absorptiom -Removes static electricity with lionize My company SJ INNOTECH Product model
Electronics Forum | Wed Jun 17 07:08:58 EDT 2015 | armandogomez
Hello PAWEL before you go and buy a machine that cleans you pcb, have you check the current conditions where the pcbs are storage? hair, speck of dirt, fiber and other things sounds to me that the area where you work with these pcbs is not very clea
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
winsouce.jpg)
