Electronics Forum | Wed Jan 01 11:03:31 EST 2003 | davef
We just use stare titanium stiffeners from the wave soldering area. Titanium is probably over-kill for your needs, but will work. Sources for titanium stiffeners are: * APT 603.622.1211 Tom Dimagio * New Era Technology 603.669.77971 Jessie Ward * B
Electronics Forum | Tue Mar 13 03:21:18 EDT 2018 | 3l3ctro
Do you also have some accessories that you use to keep your board level assemblies secured? I'm planning to buy some truck accessories (headache rack and chains) at http://4wheelonline.com to keep the boxes safe on the bed of my truck.
Electronics Forum | Mon Jul 31 11:06:45 EDT 2017 | capse
Fancort industries offers v-score separation systems. ASYS Group offers sawing and router depanel equipment.
Electronics Forum | Mon Jun 21 13:53:42 EDT 2004 | waveroom
The Fancort flat racks are the most economical. That said, the problems encountered when populated boards are placed into the rack you can't utilize all slots. If populated to the edges you can't use at all. There are somewhat economical racks that a
Electronics Forum | Thu Aug 04 07:50:49 EDT 2011 | mosborne1
Thanks Dave - IF you look ath the Fancort RA-18HT. This is a high temp plastic that will handle 350 F. This is what we need, but in the 8 1/2 by 20 size. No one seems to make them now. We are a bare board manufacturer as well se wee bake boards at hi
Electronics Forum | Wed Jul 20 13:46:17 EDT 2011 | mosborne1
Does anyone have a source for high temp PCB racks? Fancort makes them, but they do not make high temp racks like we need. We used to buy Calmark and they do not make them any longer..
Electronics Forum | Fri Jun 18 13:58:38 EDT 2004 | russ
the conductive standup racks can be purchased from Fancort and are available through most distributers such as Contact East, Hisco, Future Active, technitool, etc...
Electronics Forum | Tue Aug 29 08:40:58 EDT 2006 | russ
Make a frame that is larger than your largest board, or make a few sizes whatever you chose. Contact Fancort about their modular universal wave fixtures and "enhance" design for reflow, you will get the point when you go look at fancorts website. Ru
Electronics Forum | Tue Jul 19 09:06:00 EDT 2016 | davef
We used to use those, back in the bad old times. basically, it's a router with a blade on it that is used to trim the leads of PTH components that are mounted on boards. Nasty process. Difficult to control. Messy, firing cut leads all over the plac
Electronics Forum | Mon Mar 02 21:54:10 EST 1998 | MONICA PARK
| Is there any publication or web-site where I can find out more information on the manufacturers of SMT and through hole equipment, the size of the market place, and the typical values of equipment? Dear. Sir. We are so pleased to contact with you
