Electronics Forum | Thu May 22 16:16:05 EDT 2008 | rmitchell
Hi, Our MY19 will not advance our slot 2 feeder in all tape and reel LM magazines. Other slots advance fine on the same magazine but #2 will not, no matter where we position the magazine along the machine. Any info-
Electronics Forum | Wed Jun 04 08:54:46 EDT 2008 | sys_steven
We just had an issue where only slots 9 and up advanced on any feeder, an slot 2 advanced all the time. Slot 1 and 3-8 would not advance in any position. We replace the IC's at U12 and U13 on the M1 card, now slot 1 is the only one not working. We
Electronics Forum | Tue May 27 13:27:38 EDT 2008 | tech1
Sounds like you got something stuck in the magazine bus and it blew the circuit in that lane. I think you can swap out chips on one of the computer boards in the system.
Electronics Forum | Thu May 29 12:14:57 EDT 2008 | bsumfg
Hi, I'm confused by your post. Are you saying one of your magazines does not work in the 2nd feeder postiion even if you move the magazine to a new slot on the machine or are you saying all your magazines do not work in the 2nd feeder position reagr
Electronics Forum | Wed Jun 04 00:28:27 EDT 2008 | chrispy1963
There are a couple of things that you can do. First thing to do is take a flashlight and shine it in the card edge connector of slot 2 and see if a passive component or any other part worked its way into that slot. This will cause multiple leads in
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Tue Jan 24 10:39:45 EST 2006 | O.K.
Hello everybody ! I am looking for manuals or catalogs for different makes of feeders - fuji, siemens, gsm. does anybody know where to find it ? thanks in advance, any replies will be appreciated.
Electronics Forum | Sun Feb 03 07:41:29 EST 2019 | dfl
Anyway, after both procedures, the feeder still advancing more than 4mm (like 12mm or so)
Electronics Forum | Mon Apr 10 12:54:43 EDT 2006 | cyber_wolf
Is anyone out there using the newer style Fuji feeder calibration jig ? It's the one that has the LCD on it. My current feeder cal jig just measures pick point center. This newer style gauge measures advancing arm height,bend in the advancing arm br
Electronics Forum | Sun Feb 03 07:36:17 EST 2019 | dfl
Hey Steve, I wrote to Bob, but he doesn't reply yet. Digging around, I found these: HANDLING COMPONENT VARIETY The adjustable Pocket Index function enables handling a variety of component tape reels or special component packaging. The following ins
