Electronics Forum | Mon Feb 14 14:46:42 EST 2005 | russ
We use Samsung and our 24mm feeders have 8,12,16,and 20mm pitch settings. I have found 20mm pitch quite common. My favorite is yhe 12 on 12 our feeders don't support that, we have to put them up on 16mm feeders our cycle them 3 times on a 4mm pitch
Electronics Forum | Tue Feb 15 04:07:17 EST 2005 | Rob
Yes we have come across 24x20, & we have a couple of feeders set up for it, & no it's not that common a part but you can't be the only Mirae user who has ever tried. What do Mirae have to say?
Electronics Forum | Thu May 11 01:30:27 EDT 2006 | pavel_murtishev
Good morning, FYI, it's better to set "relative" instead of "teaching" for tape feeders. In this case optimizer will have an opportunity to change feeder position during program optimization. "Teaching" will fix feeder position and optimizer will ne
Electronics Forum | Tue May 09 21:56:22 EDT 2006 | KEN
Yes. Teach 24mm feeder. 1. Set pickup to "Teaching" or "relative". 2. Adjust coordinate. 3. Celebrate with high fives and chest bumps like in the beer comercials.
Electronics Forum | Fri Nov 09 14:42:08 EST 2001 | vickt
Great advice!........Single tier feeder set-up carts are also available through Universal instruments directly for this exact purpose. Most people who really care about this changeover time have "pit-crews" that work in the component storage areas, o
Electronics Forum | Tue Apr 03 08:34:38 EDT 2012 | thanh
REAR, NEXT TO TABLE UP AND DOWN. CHANGE FEEDER SET UP TO FIX TRAY. MAKE SURE YOU HAVE CORRECT NUMBER OF X,Y COMPONENTS IN TRAY AND NUMBER OF TRAY FOR THE PART.
Electronics Forum | Tue Oct 09 14:25:33 EDT 2001 | cal
Most PIck and place manufacturers have off line feeder set up available. Dedicating common feeder types to one side and having the other side available for job specific is also an option. *****note dedicating feeders can effect your throughput num
Electronics Forum | Tue May 21 12:58:15 EDT 2013 | highmillr
We have 2-Samsung 431's followed by a 421 on our line..We run different revision boards with similar parts. Is there a way I can run one revision feeder set up.Then switch over to the next job without having to switch feeders around for the new progr
Electronics Forum | Thu Dec 02 17:42:35 EST 2004 | resslerr
The best solution is to use a software tool which offers program optimization, feeder set-up and line balancing even if different machine types are in the same line. Check out the leading solution provider: http://www.timmsweb.com In my view, your
.gif)
