Electronics Forum | Mon Oct 08 05:48:36 EDT 2012 | vinitverma
Dear Chris, N2324 and N2325 are for nozzle down sensors. THese sensors are located on the left and right side of the left and right walls of the head assembly respectively. There are very small holes in the walles through which these sensors transmi
Electronics Forum | Wed Sep 27 17:49:41 EDT 2006 | SWAG
Open the rear door that has the cooling fans on it. Look at the wiper blade regulator, look toward the front of the machine about 8" or so and to then left 3"or 4". There should be a lexan cover/box over the board that has this pot. on it. If stil
Electronics Forum | Fri Jun 24 08:47:14 EDT 2005 | grantp
Hi, There are many aspects to consider. 1. Firstly the room needs to be designed so it's sealed, so linoleum floors than curve where the wall meets the floor, so dirt does not get trapped in the corners, and mops get all dirt and pick it up. Floor
Electronics Forum | Sun Dec 10 11:55:16 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)
Electronics Forum | Sun Dec 10 11:55:28 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)
Electronics Forum | Sun Dec 10 11:56:05 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)
| 1 |
.gif)
.gif)
