Electronics Forum | Thu Feb 14 23:08:41 EST 2013 | dekhead
Squeegee error on a 248 is strictly that sensor (reed SW) on corresponding (Front / rear) squeegee cylinder is not seeing a change in state... Either a physical obstruction preventing cylinder from exending fully - OR- if it is extending fully, then
Electronics Forum | Fri Jun 17 10:59:22 EDT 2011 | beta
yes there is - I think it is called front print limit & rear print limit
Electronics Forum | Wed Jun 29 15:42:19 EDT 2011 | dekhead
Yes it is "Print Front Limit" and "Print Rear Limit". Negative value extends the stroke, Depends on software version how useful it will be, as there are differing limits on how much you can extend the stroke. http://www.dekhead.com
Electronics Forum | Fri Jul 30 19:27:40 EDT 2010 | dman97
Hi All, Does anyone know how to repair a UP2000 that has the front squeegee lower than the rear? Can this be fixed by playing with the drive belts? The front squeegee is sitting lower than the rear and thus gives an uneven print stroke. The front s
Electronics Forum | Mon Jul 29 18:51:47 EDT 2002 | davef
Consider: * Printing: errors [ie, insufficient, excess, skipping, etc.] paste doesn�t roll in front of squeegee, paste adheres to squeegee at the end of stroke, paste does not release. * Component placement: orientation, wrong component, missing comp
Electronics Forum | Wed Feb 23 22:56:46 EST 2011 | jeffr
When I enter the "Setup Table Contact" menu, then press "Load PCB" the squeegee head should move to a mid position that I can set the squeegee height, but instead it moves the squeegee head to the front limit and displays a red error message about th
Electronics Forum | Wed Feb 09 14:48:30 EST 2005 | tinkergaloot
can anyone provide me with information on the operation of the Zevatech Print-MAT 220? Its a pretty basic machine, but my question relates directly to the squeegee blade setup and leveling the blades to the stencil. If you level the blades together
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Fri Nov 13 04:45:30 EST 2009 | lococost
Hi dave, Sorry to hi-jack the tread a bit, but,we are experiencing some problems with components falling off somewhere in our factory, you made me think about printer settings being an issue. By print print, do you mean a double sweep of the squeeg
Electronics Forum | Thu Aug 12 22:31:10 EDT 1999 | Dave F
| Hello, | | Can any netters suggest what critical parameters should be considered & what are there assoicated impacts for a solder paste printing process ... | | B.Regards, | Felix | Felix: There are some 30 variables that affect SMT solder qua