Electronics Forum | Sun Aug 30 15:32:33 EDT 2009 | jimmyboz
most fuji error codes are 8 digits, A21E is 2100A21E, it is a report from the MCS that transmission has failed (we knew that) Hit control E from the main screen of the MCS, there should be another error reported from the cp6, ie. 1101000 is x data ou
Electronics Forum | Tue Feb 15 06:53:50 EST 2005 | cyber_wolf
It seems that every time we do maintenance on our CP6 windmills, we have a lot of problems with nozzles sticking up inside the holders. It seems to happen for a while, then it goes away after we run for a bit. We follow the Fuji maintenance procedure
Electronics Forum | Wed Jun 21 04:11:31 EDT 2006 | daxman
Are you familar with using the mecca mode on Fuji machines? There is a procedure I can take you through that will check the servo amp and allow you to adjust it. Is your machine useable at all? can you get it to pass zero set? If you can, view your s
Electronics Forum | Thu Mar 30 12:38:14 EST 2006 | Tech
Also why I am at it. In the book CP-6 Series Maintenance Manul ( Fuji Part # MNT-C060-11.3E ) in Chapter 4 page 4-1-11 it says " The clutches should therfore be cleaned regularly, using the grease cleaner (ThreeBond 2706) provided with the machine."
Electronics Forum | Fri Dec 14 18:32:39 EST 2007 | kroberson
What machines have you worked with previously? Depending on the programming software used, CP6 can be relativly easy to program. CP6 has been a workhorse in the industry for a long time. One the process is set up, maintain the machines acording t
Electronics Forum | Fri Nov 09 07:28:48 EST 2007 | jola
We have tested the Feeder Master and I have to say, we are not impressed at all. The main thing that we thought would be great with it was to test the feeders in full speed, but you dont get any data out from the machine so you only end up waching th
Electronics Forum | Mon Oct 22 09:50:54 EDT 2007 | cyber_wolf
The true way to track feeder maintenance is through a real time bar code reading system...For example Bartector. (We have never used this system nor do we receive any benefit from them) We currently have our CP6 feeders set up on a three month inter
Electronics Forum | Fri Mar 22 09:22:44 EST 2002 | itempea
Steve, don't forget that the first assessment you should make is whether a CP6 is what you really need. It's highly reliable, fast, but no so flexible. For a low volume, high mix, it might not be your best bet. Other things to consider: - the exper
Electronics Forum | Fri Oct 26 02:12:35 EDT 2007 | jola
Hello. In a stupid way I'm glad not to be alone in the feeder jungle. We have the same ammount of feeders with a mix of Fuji and Panasonic high spped feeders as the main problem. The way we do it at the moment is that we have marked up all with a num
| 1 |
winsouce.jpg)
