Electronics Forum | Fri Aug 01 06:54:22 EDT 2014 | tegel
Hi, I don't have any solution to the problem, but the component is an EMI-filter and not part of the machine. // Tegel
Electronics Forum | Mon Aug 29 13:34:58 EDT 2016 | mhanrahan
We had this issue with our old MV 150. This was usually due to clogged/dirty or bent nozzles, or clogged dirty filters on the vacuum supply to the head.
Electronics Forum | Thu Jul 30 12:55:16 EDT 2020 | fujipro
If there is no visible fault on the affected Shaft, perform maintenance on the Head. Replace Filter and exchange the Mechanicial Valves or replace the O-Rings on it.
Electronics Forum | Tue Jul 14 10:19:22 EDT 1998 | Ben Salisbury
| | Hi, | I'm an SMT tech in a major OEM in Scotland and we have just purchased two Fuji QP's. Does anybody out there have a list of do's and don'ts especialy regarding preventative maintenance and common faults. Jim- I Haven't used the QP's yet
Electronics Forum | Wed Apr 02 11:42:28 EST 2003 | ricardof
Hi, we are using coplanarity chek systems on FUJI IP. I understand on a rough standpoint that basically this system is a GO - NO GO filter.But I would like to know if there are any options to have other results (Analytical results) with that option o
Electronics Forum | Tue Dec 16 22:38:51 EST 2008 | ashley
Hello Sr.Tech, Please write direct to apexservice@apexsmt.com I am sure they are able & willing to provide to you sample nozzles for your evaluation. Just let them know the sizes that you need. Apex SMT in Singapore is also be able to support other
Electronics Forum | Sat Jan 18 03:18:04 EST 2014 | smtspareparts
Should be too high temperature on somewehere on machine, 1 Check cooling oil tank, If the cooling oil need replaced? Check the radiator of cooling tank, withdraw the filtering net and clean it,and clean the dust off the radiator of cooling tank wi
Electronics Forum | Thu Feb 24 21:04:29 EST 2011 | ghosteye2011
Various kinds of high quality SMT nozzles, cutters, filters, etc. for more than 10 years, Assembleon nozzle, NXT nozzle, FUJI nozzle, Hitachi nozzle, JUKI nozzle, KME nozzle, Panasert nozzle, Philips nozzle, Samsung nozzle, Sanyo nozzle, Sony nozzle,
Electronics Forum | Thu Aug 03 19:34:17 EDT 2006 | davef
You might consider an oxygen monitor (or lack of oxygen monitor). A fast response-rate analyzer should be used. There are several types of analyzers on the market and each has different limitations. * If you are looking for a measurement ranging fr
Electronics Forum | Tue Jul 11 23:28:59 EDT 2006 | donb
Hi All, I have a continuing problem here with mis-alignment of parts on one of our Fuji CP-3 machines and I thought one of you esteemed engineering types may be able to give me a clue as to where the problem might lie. I have a Fuji trained enginee
winsouce.jpg)
.gif)
