Electronics Forum | Thu Sep 14 14:50:08 EDT 2006 | gillmore
I am need of one or all of the following items of literature for a Fuji GP551E Screen Printer: Operating Manual Maintenance Manual Schematic Parts List
Electronics Forum | Thu Dec 16 15:00:20 EST 2004 | glaucon
Simple differences. Both processes require a very similar machine platform, controlled motion, vision fiducial recognition and alignment of a substrate (PCB or hybrid ceramic) to the "image", the image being either a stencil (hence stencil printing)
Electronics Forum | Sat Nov 07 18:38:32 EST 2020 | enzik
Hello to all, The Fuji GSP III screen printer was working well yesterday. This morning, the machine turned on and the display screen was showing nothing. I went to the back of the machine and reset one of the VM1152A. The display screen is now showi
Electronics Forum | Mon Nov 29 13:01:35 EST 2004 | bobsavenger
I have a DEK 265LT screen printer and a Fuji bare board loader. I cannot get the two machines to talk through the SMEMA cable. I have the personality card for the DEK and I have the correct cable for a FUJI machine. Is there something that I nee
Electronics Forum | Fri Feb 12 14:06:28 EST 1999 | Craig Lowe
Bill, I would go with the second piece of advice by leaving a little film of solder paste on the screen. This is good advise if you are using a lookup/look down type of vision centering. Like on MPM and newer Fuji. On older Fuji GSP2/3 style printer
Electronics Forum | Fri May 16 03:37:04 EDT 2008 | ianlg
Hi There is a Benchtest on the EPP Stand at the SMT Hybrid & Packaging exhibition that may be on interest to you where 11 printers are going to be tested against each other. It should be interesting to all who are looking to purchase a screen printe
Electronics Forum | Sun Mar 07 01:04:21 EST 1999 | Paul Peterson
My printer evaluation has come down to the Fuji GP-6 or the Dek 265LT. I'm looking for experienced opinions on both of these options, we're currently running an older vintage Dek 265 printer that gives us constant electronic system problems. The vis
Electronics Forum | Fri Oct 25 14:46:50 EDT 2002 | russ
Leading edge, This is used to determine the orientation of the board as you want to run it. If you use center justified stencils this is usually not an issue since you can just turn the stencil any which way you want to. If you are using front/rear
Electronics Forum | Wed May 20 11:13:45 EDT 2015 | josealatorre
1. DEK 710 for Screen Printing 2. Fuji NXT for Pick and Place 3. Vitronics XPM3i Oven
Electronics Forum | Thu Jul 22 12:50:04 EDT 1999 | Jennifer
I use a Transition Automation Semi- Automatic stencil printer with laser cut frameless stencils. Just out of curiosity, who's holding the market for the semi-automatic screen printers these days aside from Transition Automation? I know MPM offers
.gif)
