Electronics Forum | Fri Jan 25 08:54:33 EST 2019 | dfl
For the first time, I'm really looking at to the power transformer for the IV-C pick and place (the big big one, at the middle). As I understood, is this transformer converting the 220V to 127V? I realize that the camera monitor is 127V and the PC PS
Electronics Forum | Mon Sep 08 08:59:45 EDT 2008 | davef
You're correct: * Sealed relays should not be cracked or have moisture intrusion. * Hand soldering relays is going to be expensive. [Using a mini-solder pot for this might reduce some of the burden.] The good part is that the problem is gross enough
Electronics Forum | Sat May 14 13:07:42 EDT 2005 | gc
We have surge suppressors on every machine we have as well as suppression on the mains coming in the building. The power in the area has always had too much noise and we did have losses due to surges during storms and such. Three phase surge suppre
Electronics Forum | Tue Apr 30 10:03:31 EDT 2013 | mmjm_1099
Got it powered back on Friday.... We did check the UPS (power-supply)and indeed it was bad. So we referenced the manual and found you can bypass the UPS all together. So we just directly plugged the machine past the UPS. Well the machine is running b
Electronics Forum | Tue Oct 14 07:30:00 EDT 2014 | rob
For low voltage and current applications there are also some nice SMT conductive foam pads that come in on tape. http://www.gore.com/MungoBlobs/621/772/SMT_Grounding_Pads.pdf I think Laird also do something similar. We place them with no problem.
Electronics Forum | Thu Oct 02 15:28:19 EDT 2014 | arifa_anees
it all depends on the situation, your circuitry and components. ground place should always be below or above the signal and power traces to minimize loops and reduce EMI generated by the board.If you have multiple power voltages and a 4-layer board y
Electronics Forum | Fri Sep 12 06:53:32 EDT 2014 | spoiltforchoice
Surely this depends on the scenario? Quite a few manufacturers feeders use spring contacts http://www.harwin.com/product-search/P20-0/ perhaps a bit like these, so your PCB would simply have pads to align with those contacts. Of course this relies o
Electronics Forum | Thu Apr 12 15:21:12 EDT 2012 | jdengler
Have you tried to do a reset start? When Fuji's act weird the first place to start is a reset start, then re-load the Proper Status and Program. Jerry
Electronics Forum | Mon Jun 09 22:19:11 EDT 2008 | davef
The GC-Prevue products are: * GC-Prevue * GC-PrevuePlus * GC-CAM Edit * GC-PowerStation * GC-PowerPlace
Electronics Forum | Wed Jun 04 06:37:10 EDT 2003 | cdowny
I am looking into pick and place for medium to medium-high production with semi frequent changeovers. I have been looking for a little while and nosed around at APEX also. I am not interested in any used products, I have been down that road before
A dealer of high quality Used SMT Equipment, Used Plastic Injection Molding Equipment, Used Machine Tools, Used Semiconductor Machinery, and Used Industrial Machinery.
Equipment Dealer / Broker / Auctions
104 East Street
Middleton, MA USA
Phone: 978 790-2774
winsouce.jpg)
