Electronics Forum | Mon Jan 12 18:06:38 EST 2004 | Kris
Hi, Is there any standard for voids in a leaded device or a chip component ? IPC 7095 lists maximum allowable voiding for BGA devices but has no information on leaded devices Appreciate your help- thanks
Electronics Forum | Fri Jan 23 10:39:35 EST 2004 | patrickbruneel
Kris, I assume with voids you mean acceptable solder coverage of pad and lead. As Dave mentioned I also have not seen any specific studies on voids, but workman ship standards exist about acceptable coverage of pad and lead (both consumer and MIL)
Electronics Forum | Wed Jan 14 08:45:04 EST 2004 | Kris
Thanks Dave Will appreciate if any body has any published information on a study they did for voids in leaded devices Will try to talk to them Dave
Electronics Forum | Tue Jan 13 22:07:42 EST 2004 | davef
No, there is no such information. Choices are: * Recognize that any voiding is a process indicator and that when observed, indicate a requirement for taking corrective steps. * Tell your quality people to quit looking at components other than BGA wi
Electronics Forum | Mon Jan 19 18:49:42 EST 2004 | menglong
we are facing the same problem,and we are looking for some research result about voids.who can help to provide these ones ? any suggestion, pls keep me informed contact me :zhanglg@tpv.com.cn
Electronics Forum | Thu Mar 09 20:48:30 EST 2000 | Dave F
Van Hoang: Welcome to SMTnet!!!! Regarding your problems: 1. Cleaning glue: Check the SMTnet archives. For instance, a recent thread was: cleaning glue off of stencils - pr 13:41:43 03/03/2000 2. Bridging on the wave: Bridging on the wave h
Electronics Forum | Thu Mar 09 20:48:30 EST 2000 | Dave F
Van Hoang: Welcome to SMTnet!!!! Regarding your problems: 1. Cleaning glue: Check the SMTnet archives. For instance, a recent thread was: cleaning glue off of stencils - pr 13:41:43 03/03/2000 2. Bridging on the wave: Bridging on the wave h
Electronics Forum | Wed Jul 14 19:15:59 EDT 1999 | JohnW
| Can plcc's be glue on the a board if not why? | Ron, The biggest problem you have with PLCC's is the hieght of the base of the component from the board, if you can get a glue dot high enough then yes you could do it. Probably the best method is d
Electronics Forum | Thu Jul 19 09:23:52 EDT 2007 | patrickbruneel
Chris, To my knowledge the only difference between leaded and lead-free components is the termination plating. What has changed in the component design that makes them resistant to higher temperatures?
Electronics Forum | Fri Jul 13 16:07:42 EDT 2007 | wana
Hello All. Can the experts in the lead free field guide me to the articles / data confirming that it is OK to use lead free components in the normal "leaded" (Pb) SMT process. And also if any changes in the process would be required to be made. Th
