Electronics Forum | Fri Jun 12 18:21:52 EDT 2020 | proceng1
I've had components move in the pocket and cause mis-picks. Generally, the part moves, but settles in the pocket after a moment. So I slowed down the pick up speed. It gave the part in the feeder a chance to settle before picking.
Electronics Forum | Thu Mar 05 12:58:01 EST 2020 | joeljacobo
Hi everyone, I hope you can help me with this matter. We have a Hanwha SM482 machine and a series of projects involving many 0201 components (resistors, capacitors, inductors, etc.) will be carried out. Making the prototypes I noticed that there is
Electronics Forum | Wed Jun 24 08:28:16 EDT 2020 | pickplace
Hi Jacobo, it would be importatn to know what kind of error the machine is displaying. Are the chips in paper or plasic tape? Did you check pickup coordinates and hight? Have you many false edge pick vision errors? Then I would switch off the tombest
Electronics Forum | Tue Jul 14 10:24:33 EDT 1998 | JMCoogan
Wayne We (Universal Instruments) started demonstrating the placement of 0201 chips at the last Productronica show in Germany. But at this point in time, you will be hard pressed to find anyone using it in production (although the placement equipment
Electronics Forum | Tue Jul 21 11:21:20 EDT 1998 | JM Coogan
Wayne SANYO is focusing on the bulk feeder design concept developed and licensed by Taiyoyuden Co., Ltd of Japan (instead of the Nitto Kogyo, i.e. pneumatic design). They are making very good progress with 0402C and 0603C components. So far, we hav
Electronics Forum | Thu Aug 28 02:51:01 EDT 2014 | padawanlinuxero
When you say "selecting correct value of the small chip components during assembly", you are referring to caps and resistors? and that you want to know that the correct cap or resistor was place in the correct location? your assembly is surface moun
Electronics Forum | Mon Apr 15 15:34:07 EDT 2002 | Bob
Hi, I have loads of experience with QP132's. You can change over product quite easily depending on a few things: - � The board sizes should be the same otherwise pallet adjustment can take an hour or so. � If you can fit all the feeders on one set-u
| 1 |
winsouce.jpg)