Electronics Forum | Mon Jun 01 18:54:58 EDT 2015 | frix
Good day, I've got a situation with a Siemens 80S15. Everything used to work fine. One day when I switch the machine on the star (12 segment star in the head) just keeps on running when a head reference is commanded in SiTest. Can somebody please g
Electronics Forum | Thu Jun 04 07:54:53 EDT 2015 | frix
Good day, Thank you very much for the response. We are currently running 0603 and larger. I don't think there is any components that got into the head. I've been reluctant to open up the glass encoder of the head - it seems that a lot of the parts
Electronics Forum | Wed May 08 10:40:48 EDT 2013 | huske
We have had this problem before, and Phil was pretty close. On the hydra where the vacuum tubes are connected to the tools shafts you should see a red light inside there. this light locates a lazer cut mark on each of the tool shafts, this lets t
Electronics Forum | Tue Jan 30 17:36:59 EST 2001 | slthomas
Looking for recommendations for references on quality an process control.....SPC, process capability (cp, cpk), etc. My feet are a little wet on this stuff, but we'll be implementing soon so I'll need a reference to bail me out on occasion. You kn
Electronics Forum | Thu Jun 04 02:58:48 EDT 2015 | oxygensmd
I saw the same problem before we changed to S20. S15 has a problem with the components. They can fall into the head easy. Try to remove the head, clean the inner encoder and check there isn't any small component. If you work with 0402 or same/smalle
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Sun Feb 09 19:16:22 EST 2014 | navworx
Was running production when the head just came to a stop, motor went off, error window said to home. Upon attempting to home, got message: G1T2 homing error; index mark not found. I've tried rebooting the machine, but this error still appears. Any
Electronics Forum | Thu Feb 16 15:19:38 EST 2006 | Samir
Read Ralph Woodgates', "The Handbook of Machine Soldering." Ralph is a true lead-head from way back, and his expertise is Wave Soldering. I know later editions have sections on that new fangled technique, "Reflow Soldering", but Ralph does a very c
Electronics Forum | Sat May 04 11:24:08 EDT 2013 | amelby
Hi, I have been having a problem with my My19E's hydra. The machine comes up with an error "Failed to locate HYDRA tool reference marks" and stops running. It does not happen for about the first two hours of running. It starts to happen after that an
Electronics Forum | Wed May 08 11:20:24 EDT 2013 | amelby
Thanks for the info on the Hydra tubes that will be helpful. I found the answer from one of the Mydata techs. The Camera needs the hydra head to go slower then 1.9m/sec and the setting was at 1.8m/sec. They found out that even if the machine was set
winsouce.jpg)