Electronics Forum | Thu Aug 26 07:35:32 EDT 1999 | Robert Meston
For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. Does anyone have any new ideas on how t
Electronics Forum | Thu Sep 02 11:47:55 EDT 1999 | ScottM
| For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. | | This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. | | Does anyone have any new idea
Electronics Forum | Thu Aug 26 11:01:47 EDT 1999 | Wolfgang Busko
| For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. | | This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. | | Does anyone have any new idea
Electronics Forum | Wed Sep 01 14:07:41 EDT 1999 | Dave F
| For space contracts we have to mount chip capacitors/ resistors etc 0.1 to 0.4 mm from the pad height. | | This is to compenstae for the CTE differential in the substrate/component and also to ensure cleanliness. | | Does anyone have any new idea
Electronics Forum | Tue Aug 04 11:10:22 EDT 1998 | Chrys
| Hi Stoney, | Justin is giving you some good advice, unfortunately these kinda' problems sometimes call for the ol' D.O.E...otherwise, you could be chasing your tail for a while until you figure out exactly what's causing your problems. | Has
Electronics Forum | Wed Feb 10 15:49:53 EST 1999 | Gary Sickenger
Helo, Is it common for actual print height of solder paste to exceed the stencil thickness. For example If the stencil is 6mill thick and the actual height of the print is apx. 10 or 11mill. What causes the paste height to be greater than the sten
Electronics Forum | Sat Jan 08 06:37:44 EST 2022 | jineshjpr
Hi, Noticed that MPN--MAL215099913E3 used in one of our assembly with 22mm component height. In General 15mm height is right to set height calibration (98 % of the parts will be covered with this height dimensions except specific Connectors, Transfor
Electronics Forum | Mon Dec 29 14:47:36 EST 1997 | justin medernach
| how to determine the optimum solder paste height ? Ray, This is a gross misconception within the industry. There is no optimum solder paste height, per say. The effectiveness of a solder joint should be quantified in volume. Use your process as
Electronics Forum | Fri Feb 18 23:21:00 EST 2005 | JSS
Hi Everybody, Mostly customer asked about the solder paste height checking after printing process.Is it compulsory to check the height if we are using stainless steel stencil and metal blades in fully automatic printer.Any technical answer to their
Electronics Forum | Fri Feb 22 13:17:56 EST 2008 | cyber_wolf
0201 Feeders are a different height than regular 8X2's I have put them on a surface plate and measured them with a height gauge. FYI: They make 0201C (Capacitor) and 0201R (Resistor)Again the difference between the two is height. Also it is CRITI
