Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero
Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr
Electronics Forum | Mon Aug 16 18:39:21 EDT 2021 | SMTA-64387687
Utility-Installation-Hydra Tool Utility "Enable Hydra Tools"
Electronics Forum | Tue Dec 06 15:57:07 EST 2022 | robertobsuinc
I'm using 15E with tpsys software 3.1.2 and the machine is not using the hydra tools, hydra bank and tools are installed, package and components has the hydra tools, but is only using single mount.
Electronics Forum | Thu Mar 28 16:11:12 EDT 2024 | kingkelvin
In calibration menu - I see coarse measurement of z unit offset, z-unit offset, measure hydra camera z level, coarse adjust hydra tool offsets, and measure hydra tool lengths 1 - 8 - would it be any of these that I should run?
Electronics Forum | Wed May 13 15:57:43 EDT 2020 | azdback
We have been working on an intermittent error on our hydra. And it seems to happen only after several hours of production have passed, it doesn't happen during the first part of the shift. Our hydra goes from working fine for several hrs to making
Electronics Forum | Mon Jan 02 09:39:34 EST 2017 | dyoungquist
I do not know the limit for component height on Hydra.
Electronics Forum | Fri Sep 02 10:14:18 EDT 2005 | Mity-C
Hi, We have done many 0402's with Hydra. We have done 0201's with the single head on Linescan but have yet to actually run them on Hydra. We now have a machine equipped to do this with the corresponding hydra tips. I will update as soon as I have an
Electronics Forum | Mon Dec 19 07:55:30 EST 2016 | bk
I am assuming that these are the round aluminum electrolytic caps. The problem may be that they are too wide to put on 2 hydra heads next to each other. Plus the hydra heads are not that great at placing tall parts. I would not let the hydra place th
Electronics Forum | Thu Mar 28 16:51:00 EDT 2024 | tey422
Since you only saying it's the hydra error, then only run the hydra calibrations. Sometime the calibration can end up causing more issue if not run it correctly. I would do the hydra camera Z level (1st). If it fixes the issue then you no need to do
Electronics Forum | Tue Aug 09 08:22:04 EDT 2005 | cyber_wolf
Did you know that if you break a tool shaft on your Hydra 2D head, you need to replace the entire Hydra head ?
