Electronics Forum | Sun Dec 04 16:54:52 EST 2011 | andersenequipment
I have a mydata tp-11, crap hard drive, When I look to replace the hard drive with another, the machine ask me for a password or passcode. Anyone help?
Electronics Forum | Mon Dec 19 15:56:12 EST 2011 | armandogomez
Hi! I have 2 Mydatas in here, I think the 2 passwords are not the ones you are looking for, Might be that the software is looking for something call the Magic Word? if so, you need to contact MYDATA so that they can send you the "Magic Word", you se
Electronics Forum | Tue Jan 24 20:05:24 EST 2017 | erici
we have one dot matrix printer and i would like to connect it to the TP9 machine. The parameters settings for printer is "protected" so i cannot assign the printere to the machine. How do i "unprotect" the parameter to allow me to make changes?
Electronics Forum | Thu Jun 10 17:22:10 EDT 2021 | vtdivtecs
thanks! definitly not the answer I wanted to get, but it's good to hear it. Back when we sourced the machine a few years ago I was kinda against buying it as our production scale is so small it doesn't add a ton of value, BUT the electrical verific
Electronics Forum | Wed Jul 13 08:42:02 EDT 2005 | mikeattekfab
I am looking for an additional Tray wagon for our Mydata machines, anyone have a working one they do not need? Please let me know. Mike
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Fri Mar 20 14:30:33 EDT 2009 | KP
I'd like to manually send programs to the machine but I'm not sure where the files are stored.
Electronics Forum | Thu Mar 26 13:31:37 EDT 2020 | rgduval
As everyone else said, if you don't have CAD, it's a pain to digitize the gerbers. So much so that we only did it once when I went to CircuitCam training. After you digitize the gerbers, you have to merge the BOM with it. And you have to tell it p
Electronics Forum | Wed Jun 09 23:58:59 EDT 2021 | SMTA-64387687
The electrical test, on those older machines, wasn't very exact. Try to expand the tolerances, 25-30% for caps and 10% for resistors, and see if that solves your problem. Also, if I remember correctly, if you go into the layout and single-place the c
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
.gif)
