Electronics Forum | Mon Jan 03 14:38:42 EST 2011 | leemeyer
I had this problem awhile back and it turned out to be a problem with the computer Bios settings. The battery had gone dead and the settings were set back to the default state. Luckily I have 2 of these machines and was able to reset the Bios configu
Electronics Forum | Tue Feb 01 19:02:48 EST 2022 | proceng1
USC PArk is your underside stencil cleaner. The camera pushes it back and a magnet grabs it and holds it back. Ours did this many years ago. I pulled the rear cover and initialized the machine, when the camera pushes the stencil back, grab it and
Electronics Forum | Wed Feb 02 08:11:03 EST 2022 | openindus
Thanks for the answer. Our camera doesn't even move during USC Park initialization. I assume it's a condition which isn't met to launch the sequence, but all the sensors seems to be fine. Could you send me the log (SECSDBUG.TXT) of your machine dur
Electronics Forum | Thu Dec 30 20:48:09 EST 2021 | openindus
We acquired the machine few weeks ago and it was working fine until the printer won't initialize anymore with "USC park failed" error. It seems that the printer won't respond to "4 MAXY_SP 61,0" message. Is someone has already en
Electronics Forum | Tue Mar 14 17:05:45 EDT 2023 | helder_remelhe
Actually we have problem in an machine Samsung SM411. the machine stop the in Initializing machine I/F. i tried remove the VME-PCI and clean the connector and put again, change the CAn board and the result is the same. someone have an ideia of the
Electronics Forum | Fri Mar 17 12:25:46 EDT 2023 | previnmoore
I didnt get a code. its just dead.
Electronics Forum | Fri Mar 17 11:29:45 EDT 2023 | proceng1
Do you get an error message? IS there a code? Will it initialize again, but just stop? Or is it dead now?
Electronics Forum | Sun Aug 13 22:31:58 EDT 2023 | cspasol
Hi! I have encountered this problem so many times. Here are the possible cause of your machine problem. 1. PCI board or PCI to motherboard cable. 2. VME memmory card. 3. VME board itself. 4. Power supply for VME board. Hope could help.
Electronics Forum | Tue Nov 15 19:31:54 EST 2005 | eeltec
>I/OPERATION ==> >1/RUNNING ==> but any command that I try gives an E100 error and in the left side of the monitor a square with: Conditions Initialized Waiting Emg stop (in red) org incmp (in red) Interlock (in red) data comp Use Vac
Electronics Forum | Thu Apr 26 09:03:35 EDT 2007 | ck_the_flip
3d is good for initial verification that your screen printer and stencil is producing the desired paste height. 2D verification is more than sufficient during regular production. That being said, your best bet for a 3D machine is to go cheap - buy
