Electronics Forum | Fri Oct 23 18:13:53 EDT 1998 | Dave f
| I am looking for detailed information on the SECS 2 protocol that is part of the SEMI General Equipment Module interface. I was not able to get detailed information from the SEMI web site and was not able to find anything on the web. | | I am look
Electronics Forum | Fri Oct 23 15:15:51 EDT 1998 | Dave f
| I am looking for detailed information on the SECS 2 protocol that is part of the SEMI General Equipment Module interface. I was not able to get detailed information from the SEMI web site and was not able to find anything on the web. | | I am look
Electronics Forum | Thu Dec 03 14:45:16 EST 2015 | ttheis
Thanks. Our older oven does have a basic PC interface but no SMEMA. Maybe I can write a short program for the oven's PC to pace the boards into the oven. I could interact with the conveyor's SMEMA interface via low-cost Arduino or something similar.
Electronics Forum | Thu Dec 03 14:40:27 EST 2015 | proceng1
When we had a line that ended at an older reflow oven without SMEMA controls, I ran a momentary switch to the two pins in the connector. I push the button and the conveyor pushed the board onto the edge-hold of the oven. As a joke I labelled it "LA
Electronics Forum | Wed Nov 29 00:43:45 EST 2006 | callckq
Dear all, Recently, we run 2 models with heat sink attachment on top of this BGA(on top of this BGA, there is flip chip attached at the center of the BGA). Hence, the center of the BGA is higher than corner/side. We used conventional way to attach
Electronics Forum | Wed Jan 24 22:38:45 EST 2007 | electrovert
Hello, My first time post up here. I have a problem with thermo runaway on upper zone #5 on the Omni 10 Electrovert. We changed the thermocouple #5 but the problem came back up. We swapped Sensoray board 8 and 9, swapped board #3 (T/C interface boar
Electronics Forum | Wed May 30 13:54:57 EDT 2007 | rgduval
Jeremy, Would socketing the chip help you guys out at all? One of the sales rep's I use also rep's a company that builds custom sockets/interface boards for BGA packages. I can get their info, if you're interested. cheers ..rob
Electronics Forum | Mon Oct 15 12:13:00 EDT 2012 | lkavan
Hallo friends, I am looking for interface board for Tenryu MT5530. Its name is DIF3-1. If you want, I can offer servo drivers or some pneumatic feeders for change. Thank you for help.
Electronics Forum | Mon Aug 31 19:53:17 EDT 2020 | inspiredmorris20
thank you both, We removed the connections and cleaned them. unfortunately no success, we are testing the conveyor interface board to see if we have a bad board. additionally we found that power supply #3 and #4 do have 110v going in but do not have
Electronics Forum | Tue May 20 04:34:59 EDT 2014 | sarason
Well that would be a response from the VME bus. Is the PCBoard, the only controller on the buss, or is there a second controller that talks to interface boards etc. If so you might just have a problem with the second controller. Check the control sig
winsouce.jpg)
