Electronics Forum | Sat Mar 28 06:45:31 EDT 2020 | aswa1111
Hey everyone, I hope all of you doing well this time of the year. We have an old Juki / Zevatech 740 pick and place machine and we got a problem with the vision alignment, every placement is off by 2mils. How can you run an offset calibration on t
Electronics Forum | Tue May 14 02:01:56 EDT 2013 | leeg
We are having numerous issues placing BGA and IC's on a Juki 750 using laser, the machine has been recently calibrated but we are getting twist and misplacement quite often, any ideas?
Electronics Forum | Sun Mar 10 16:16:35 EDT 2019 | sam512bb
Good day All, I was curious if anyone has a source for Juki/Zevatech PM575 Calibration jigs? My machine's placement is off and various a bit and so it was recommended to calibration the laser alignment. Sadly, there are no service centers located a
Electronics Forum | Mon Jan 21 08:44:00 EST 2013 | emeto
Hi, as far as I remember Juki machines have sendor to check if there is a feeder high. So you have several thingd to check here: 1. Check if there is a feeder high 2. check the sensor calibration. I think it is a beam from one side that goes streig
1 |