Electronics Forum | Wed Jan 27 11:22:51 EST 2010 | fredc
Hello TQS, We have made Micro Mechanics adapters for Mydata. The Micro Mechanics tips are used in die bonding machines. I have no doubt that an adapted nozzle would hold your die securely. From Grants posts in the past, he had problems with placement
Electronics Forum | Tue Apr 02 13:43:54 EDT 2013 | ericrr
On one of the products uses a QFP (Quad Flat Package)which is not going on straight, maybe 20 pins per 4 sides. sometimes I have to tweak the alignment before the board goes in the oven, this practice can be a bit of a worry if you over tweak it - pa
Electronics Forum | Fri Apr 06 08:45:30 EDT 2018 | rob
Hi Reckless, No, I don't think it's a $1K job, just for the hours needed. You still need to learn the absolute basics, such as navigating the menus, creating a program, nozzle changing, identifying parts with the laser and camera, Pick timers, z hei
Electronics Forum | Thu Nov 10 23:43:33 EST 2022 | sarason
Are you using the correct nozzle for 0402? Cant remember the number OTTOMH but 501 rings a bell. somewhere I have the table, it is in the Juki service manual IIRC. This would explain placing all others okay but 0402 is not very good , Senoirtech is c
Electronics Forum | Mon Jan 09 20:09:44 EST 2023 | crystalw4280
Smt juki 2060 is constantly throwing Tombstone error messages when using 0402 parts. Is there something possibly that needs adjustment? Almost every part comes up with the error message at the beginning of the Run and they're all tombstone messages b
Electronics Forum | Thu Mar 30 08:04:56 EDT 2023 | hub
Hello, I'm looking for zevatech (juki) 570 owner that could help me to resolve my problem. I had the following error that occure just before (or sometime a few after) homing the machine : "E7018:Driver Error KNOCK position error ". Previsously I had
Electronics Forum | Fri May 27 14:37:05 EDT 2005 | Frank
Look into the Juki KE-2060E machine. I have been extremely pleased with this machine. It will hold 80-8mm feeders, place 0201 (0603-metric) up to 74mm square ICs and BGA, 150mm long connectors. Up to 25mm tall components. It can handle up to 30 t
Electronics Forum | Mon Jul 11 11:05:53 EDT 2016 | bradholland
thanks for the replies so far. So far I have been relying on the board clamp on the machine that closes when the pwb is loaded. I have also been doing these tests with double sided tape on the pwb so i can clean them off easier afterwards. I have
Electronics Forum | Wed Jul 02 09:22:20 EDT 2008 | dmunson
Thanks Real Chunks. We currently have an RPS opus selective solder machine that we plan on keeping. It is configured as a 3-nozzle (!) one-pump (!!) point selective solder machine w/ nitrogen preheat. Custom wet nozzles. We use lead free SN100C sold
Electronics Forum | Wed Mar 29 03:40:06 EST 2006 | Frank
The Juki 2060 can have both front and rear trolleys and you do not loose any feeder locations. My question was why can't the Assembleon put trolley on the rear? I recently visited a friend at a company that used a lot of Assembleon and compared run