Electronics Forum | Tue Mar 30 10:57:54 EST 1999 | Steve Gregory
Hello, I'm a student assistant in a research project that deals with the simulation of PCB assembly systems. At the moment I collect information about SMDs. My problem is how to assign the correct feeder width to various devices in a simulation. Is
Electronics Forum | Tue Jul 19 12:36:03 EDT 2016 | jbuckley
My company uses both Juki electric and mechanical feeders. Yes, electric feeders are much more efficient than mechanical as far as pick speed and general feed speed. However, if a reel runs out, it usually takes our operators under a minute to change
Electronics Forum | Mon Jul 25 03:39:25 EDT 2016 | rob
A 200% + increase in load time certainly erases > any thoughts of efficiency in my mind. We have tried the Visker Electric feeders out (Yamaha & Juki)and they are nice and smooth, with a faster recovery rate, also adjustable pitch. However, with
Electronics Forum | Fri Jun 24 22:36:17 EDT 2016 | yokywong
now days, I face a problem for JUKI electric feeder and machinery feeder. i do not know about any of electric feeder. until now, we all use machinery feeder for CF081ER 7' real holder and 15' real holder,CF03HPR ,FF12FS,FF16FS,AF24FS-OP. but this tim
Electronics Forum | Thu Jul 28 10:42:25 EDT 2016 | mnorthey
We use the Juki electric feeders, I have not seen the mechanical ones. The reel holder is the only problem we have had with these feeders(cheaply built). That said our operators are trained to change a feeder in less than one minute, (originally it w
Electronics Forum | Tue Sep 12 01:54:57 EDT 2006 | AR
I assume that you are referring to the same kind of mechanical feeders (older type) that are used on the Philips (Assembl�on) Topaz as well. First make sure that the right gear pulley spring is set to its stiffest position (the loop at the end of the
Electronics Forum | Mon Feb 11 11:28:43 EST 2013 | marcelorotofrance
yes, Bob, I agree about that. But I can't afford them by now. But the problem is that I had to reject almost the 50% of the feeders that came with the machine, because are useless even for 1206. I also work with a very old but faithfull Juki, with it
Electronics Forum | Thu Oct 04 00:03:28 EDT 2018 | gaintstar
flason smt pick and place machine: http://www.flason-smt.com/product/Hanwha-IC-placer-SM321-High-Speed-SMT-Modular-Chip-Mounter.html http://www.flason-smt.com/product/Hanwha-Pick-and-Place-Machine-DECAN-F2-High-Speed-SMT-Modular-Chip-Mounter.html htt
Electronics Forum | Fri May 27 14:37:05 EDT 2005 | Frank
Look into the Juki KE-2060E machine. I have been extremely pleased with this machine. It will hold 80-8mm feeders, place 0201 (0603-metric) up to 74mm square ICs and BGA, 150mm long connectors. Up to 25mm tall components. It can handle up to 30 t
Electronics Forum | Thu Jun 02 18:16:26 EDT 2005 | URI
Look into the Juki KE-2060E machine. I have been > extremely pleased with this machine. It will > hold 80-8mm feeders, place 0201 (0603-metric) up > to 74mm square ICs and BGA, 150mm long > connectors. Up to 25mm tall components. It can > ha
