Electronics Forum | Thu May 18 11:42:05 EDT 2006 | Rob
No more contamination or corrosion...or conversion costs..SN100C!!!! (At least I'm lead to believe!) Next time try paying for an advert.
Electronics Forum | Thu May 25 19:42:14 EDT 2006 | BOLOS
Hello..anyone who knows how much time agricultural products is allowed to have lead? I know electronics is July this year, how about electronics used in agriculture?
Electronics Forum | Tue May 30 16:14:36 EDT 2006 | grantp
Hi, Aw, come on guys, this lead free stuff is really important. A lot of our factory staff eat solder paste, and it's a bit scary to think what all that lead is doing to their health. Grant
Electronics Forum | Mon Jun 05 11:42:17 EDT 2006 | smitty
A discussion started this morning an whether we need to add an N2 line to the reflow oven when we switch over to a lead free process. We will be using OA flux. Any thoughts?
Electronics Forum | Thu Jun 08 17:21:31 EDT 2006 | PWH
EC - I hope you don't mind that I add to your question... We are running lead free assemblies now and parts that normally hang on upside down are falling off. Any advice on this from others new to lead free?
Electronics Forum | Mon Jun 19 14:04:39 EDT 2006 | slthomas
Because some lead free solders are very corrosive to anything but titanium. Also "clean it very well" is kind of a crap shoot, isn't it? Did you get your solder tested for impurities and lead %age after you did the swap?
Electronics Forum | Tue Jun 13 16:33:26 EDT 2006 | markk
Anybody doing their own BGA Reballing? I'm looking for a good kit that can handle both leaded and lead-free. Any suggestions?
Electronics Forum | Wed Jul 05 10:13:02 EDT 2006 | jdengler
Is the flux rated for lead free? These higher temps will cause most lead rated fluxes to burn off prior to the wave. Jerry
Electronics Forum | Thu Jul 06 04:41:58 EDT 2006 | Rob
MF300S is quite an old flux, & a lot has happened since then on the flow solder front - are you sure it's designed for Lead free, or is it just a traditional flux that SHOULD work OK with Lead free?
Electronics Forum | Tue Jul 18 07:50:47 EDT 2006 | adlsmt
Are the leads actually pulling off the pads or are the pads coming up as well? Did you ever try this "experiment" before you used lead-free?
