Electronics Forum | Thu Nov 10 18:58:38 EST 2005 | darby
What is the problem Peter? See a recent posting on a Y axis problem with the same style of machine. If the encoder is cactus, buy a new motor. Sorry, this is the only solution I know of.
Electronics Forum | Thu Nov 10 10:03:38 EST 2005 | meritajs
Hi, May be somebody know how we could adjust optical shaft encoder at YAMAHA 84 mounter Thank Peter
Electronics Forum | Tue Sep 01 10:55:41 EDT 2015 | emeto
Hi, 1. Take a multi meter and measure the voltage - I assume it is a DC motor(probably 24V). If you don't, check power supply,cable, relays and Driver for the motor. If you do have voltage, check sensors(sometimes sensor activated may stop your con
Electronics Forum | Fri Nov 30 00:51:10 EST 2007 | vinitverma
Here are the differences (Eclipse vs Eclipse II) Optimum Speed: 5000 vs 6500cph Feeder Positions (8mm) : 80 vs 94 PCB Loading Time : 4s vs 5.3s PCB Thickness : 0.6-3mm vs 0.5-4mm Max Component Size : 32mm vs 45mm (optional camera possible on Eclipse
Electronics Forum | Mon Aug 14 00:19:29 EDT 2017 | pandamw
Model : PDDC400-292_A 50 Ohm 2-way 2.92mm-Female Resistive Power Divider From DC to 40GHz Rated at 1Watts; 40GHz, 2.92mm-Female Resistive Power Divider; Insertion Loss 1.5dB; Isolation 10dB; Operating Temperature -40 to +70℃. Frequency Range | GHz
Electronics Forum | Thu Jan 29 15:57:09 EST 2009 | evtimov
Hi If it is a DC motor just turn the power wires and exchange the sensors. emil
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
Electronics Forum | Thu Nov 11 17:49:11 EST 2004 | pdeuel
We are having a problem with our AP-24x printer. When the vacuum motor spins up we get a 60 hz buzz into the DC drivers for the forcers and the stencle wiper. We also indicate a main power drop from 115 vac to 80 vac. The vacuum motor checks out good
Electronics Forum | Mon Apr 26 16:02:30 EDT 2010 | markhoch
Are the drive motors DC? Reverse polarity on the motors and switch your photosensors on the entry and exit end. You might have to play with the SMEMA connections a bit, but you'll figg it out. ;)
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
