Electronics Forum | Tue Feb 19 09:26:54 EST 2008 | jdengler
The low solids flux that is commonly called no-clean can affect some circuits. We are building a PCB that measures pico amps. The customer required that it be cleaned. We would rather used the low solids and eliminate a step. The customer had
Electronics Forum | Sun Dec 11 22:39:36 EST 2016 | ppcbs
We have been using the Amtech line for over 12 years now with all of our PCB and BGA Rework. The NWS-4400 is mildly active and will give better results with Lead Free Solder. Note that the LF-4300 is considered a No-Clean. However it will show lea
Electronics Forum | Mon Mar 07 16:12:02 EST 2022 | chris007
This is recommended by our EMS to make sure flux is not cheating AOI.
Electronics Forum | Fri Apr 22 10:50:51 EDT 2011 | blnorman
Quick question, how are you measuring the effectiveness of the cleaning process to remove the flux?
Electronics Forum | Sat Apr 23 00:21:10 EDT 2011 | azrina
As am doing screening right now, am not measuring the total cleanliness yet, i just observe by taking photos (FYI, am varying speed for conveyor belt for cleaning) and see whether the flux is able to be removed by certain parameters. the speed am usi
Electronics Forum | Fri Jan 28 12:18:32 EST 2005 | Chunks
Your best bet is to do a decision making matrix. Each company has so many different criteria�s it's hard to pick out which one might be important to yours. Simply pick out your top 5 paste manufactures. Next decide what your "Eliminators" are - th
Electronics Forum | Mon Aug 19 13:32:54 EDT 2019 | aqueous
ROSE testing a post-reflow assembly which has been reflowed using no-clean flux may not yield information that is helpful. No-clean flux technology works by encapsulating the flux's activators and other chemical constitutes that would be harmful if l
Electronics Forum | Mon Feb 19 22:56:20 EST 2007 | davef
Russ We agree with your comments on plugging from one side only. But... We believe that it IS possible to trap process chemicals [technically, not flux] in a blind [or any other] via. This can be done by plating the via closed, rather than pluggi
Electronics Forum | Mon Aug 30 16:10:10 EDT 1999 | Dave F
| I have looked through the IPC web page and surfed to frustration. Can somebody give me a lead? | Brian: We don't use an etched board. We use a special stencil, described below and print on bare copper laminate. 3 Solder Wetting Test. Recogniz
Electronics Forum | Tue Jan 31 11:56:12 EST 2006 | kmorris
Just wanted to take a quick poll, as to how others are taking flux density measurements on their wave solder machines.(those that don't have flux density contollers) We are using a glass hydrometer, but I see there is a digital model on the market.
.gif)
