Electronics Forum | Thu Dec 26 20:35:48 EST 2019 | luciano_zhang
I have design some PCBs but last time I met one problem they said missing the solder mask ...any one can give some suggestions why do some pcb manufacturers reject gerbers due to missing sodermask?
Electronics Forum | Tue Jan 08 09:23:18 EST 2013 | lock_2002
This is a question regarding soldermask between pins of fine pitch devices. The majority of our production designs end up with at least 2-3 mils of copper thickness on the external layers due to blind vias, wrap plating requirements, etc. Our curre
Electronics Forum | Fri Nov 07 12:48:31 EST 2003 | rholland
I have seen in the last couple of months more boards with a white hazing under the solder mask. I ran a few tests on a board to determine the cause of the white hazing underneath the solder mask. First I confirmed, or at least I think I confirmed, t
Electronics Forum | Fri Jan 09 09:43:48 EST 2009 | boardhouse
Hi Simon, The main reason that it would probably be removed would be do to lack of clearance for a soldermask dam from pad to pad. typically if the clearance from pad to pad is under .008 the solder mask dam would be removed. Min recomended dam siz
Electronics Forum | Thu Nov 19 08:20:04 EST 1998 | Earl Moon
| | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave so
Electronics Forum | Thu Nov 19 09:01:00 EST 1998 | Dave F
| | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wave
Electronics Forum | Thu Nov 19 09:32:52 EST 1998 | Earl Moon
| | | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the wav
Electronics Forum | Thu Nov 19 09:55:47 EST 1998 | Dave F
| | | | | | | For some as yet unkown reason, we have started to have some boards sag and go under the wave. The boards are surface mount top side and conventional components wave soldered. We have checked the wave hight and both the profiles on the w
Electronics Forum | Wed Sep 18 12:35:56 EDT 2002 | stepheno
Fourth - > back to design of PCB. Are there solder dams of > mask between the pads? If yes, that helps. If > not, pay close attention to stencil aperture > width and be sure that the aperture deposits less > paste by 1-2 mils per pad, centered o
Electronics Forum | Thu Nov 17 13:26:42 EST 2005 | chunks
yeah, i tried um once and they worked great. gwad dam management wouldnt buy em though.
