Electronics Forum | Fri Sep 18 10:58:04 EDT 2015 | adventurelights
Thanks, have checked the vacuum tube and ribbon cables. They seem to look ok. Theta motor seems to be woking. I'm leaning towards the theta encoder going wanky. Is that possible?
Electronics Forum | Thu Oct 01 15:25:09 EDT 2015 | adventurelights
Which encoder did you replace? The one sitting on top of the midas shaft and below the small board or the one attached t the motor next to it? I don't even know if the first one is an encoder.
Electronics Forum | Tue Aug 11 20:29:51 EDT 2020 | kumarb
Not sure if you are still looking for this motor but received a reply from Elissa (Shenzhen) overnight. Hello this is Samsung CP40 R axis motor J1301632,STEP MOTOR THETA,103H7570-7024 we have original used only price is 86usd/pcs Thank you Elissa
Electronics Forum | Fri Aug 30 05:34:28 EDT 2013 | bobpan
I would check the following: 1. Make sure the head can move in all axis including z and theta by physically moving each. 2. Check the voltage from the main power supply which is located in the middle of the machine on the top of the main board asse
Electronics Forum | Wed Jun 03 21:49:27 EDT 2020 | bboyer
Well, we finally got the machine to power up and fully boot, but now we are having issues with zeroing the axes. X, Y and Theta zero OK, and the board conveyor runs, but when it tries to zero the PWC, the rail moves to the rear of the machine, hits
Electronics Forum | Thu Nov 15 23:45:53 EST 2012 | jaimebc
robgd3, The Z motor can be purchased separately, however, the theta motor can't. You need to buy the whole midas head. I didn't get as far as dissembling the theta motor casing to get to the theta motor. That was my worse case scenario. We ran thou
Electronics Forum | Tue Dec 18 21:47:14 EST 2012 | jaimebc
So just to update and close this thread, it was the ZFIB board ( the one mounted on top of the theta motor) that was causing the theta motor to error out) Problem fixed. $ 30 dls or so from MYDATA. Hope this helps some one down the road.
Electronics Forum | Thu Feb 06 20:23:35 EST 2020 | bilalfarooqi
Hey everyone, We use a MyData MY12 machine and we are experiencing a problem with the Midas head. I recently replaced a torn vacuum tube that goes on the zfib card. The machine worked perfectly for a day and a half but now MY12 has completely stoppe
Electronics Forum | Tue Nov 13 11:41:23 EST 2012 | dontfeedphils
I can't remember what motor control cards in the machine are interchangeable, but if the controller card for the theta axis is a common control card then you can swap out the one currently controlling the theta axis with a different axis and see if t
Electronics Forum | Tue Nov 20 15:03:37 EST 2012 | jaimebc
Bruce, Since we had spares, I replaced the X wagon cables, XFMB cable, nothing. FFX Cable, nothing. Swapped mot cards, nothing. Vaccum seal, nothing.At this point I truly believe the problem is either on the theta encoder or the theta motor. Unfortu