Electronics Forum | Wed Dec 06 12:48:54 EST 2006 | seth
usb mouse not detect, and can't install driver. Need instruction on how to install driver since it won't let me copy to C:/ drive.
Electronics Forum | Wed Dec 06 14:06:55 EST 2006 | chrisgriffin
Most MPM's have a DOS operating system only, no windows. Most newer trackball drivers are installed in windows. I haven't had much luck using new trackballs because of this. You can probably find a logitech marble plus on ebay.
Electronics Forum | Wed Dec 06 23:54:24 EST 2006 | valuems
Think you will find every mpm is operating on dos base software, just in the last 2 years have they got software with windows base. The mouse is related to the version of software, and the old software requires only one model of mouse. Give up tryi
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Thu Jul 02 17:06:39 EDT 2015 | aemery
Just to clarify, you are talking about the inner black box not driving down and not the pneumatic function that brings the tactile assembly closer to the stencil? Sometimes the pneumatic shafts get slightly bent and the assembly will not retract. T
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Mon Aug 06 14:24:12 EDT 2018 | dleeper
I had a similar problem once on an acculfex. The root cause was a short on the one the wire harnesses connected to the print head. If I recall, most of the relays in an accuflex are actuated by the 24 volt bus, so if you have a short anywhere in tha
Electronics Forum | Wed May 19 09:32:28 EDT 2004 | Mr Fix it - MPM
Sounds to me like the driver for the tactile is not working. The tactile has three components to it. The first is the switch, the second is the pneumatic up/down actuator and the third is a small motor in the tactile assembly. The motor has a driv
Electronics Forum | Tue Oct 26 19:56:54 EDT 2004 | Von S
The Tactile Driver old part # is P3746 and MPM changed it to new part # 1012927
Electronics Forum | Mon Feb 22 10:19:57 EST 2010 | swag
Check/reseat all connections on axis driver card and from driver card to step motor. On older MpM's it is common to get a bad connection on the connector for axis driver power and blow components on your driver board. Reseating these connectors mig
.gif)
.gif)
