Electronics Forum | Tue Jul 05 05:23:34 EDT 2005 | kentes
We have one set MPM AP25. Its prestop position is not stable,but stop position is stable. It often occur "time out" alarm when load PCB.Which one can help us.
Electronics Forum | Wed Jul 06 10:22:04 EDT 2005 | PWH
At times we have had this problem with our AP25 due to one of the conveyor belts slipping. Load a PCB and check to see that both conveyor belts are running at the same speed. If not, tighten the one that is dragging. Hope this helps.
Electronics Forum | Mon Jun 12 10:38:00 EDT 2017 | highmillr
Getting this error more frequently. Whats causing this?? I have to reset machine every time costing man hours. After resetting its fine but does it at least once a day.
Electronics Forum | Mon Jun 12 23:52:58 EDT 2017 | aemery
Don, either you have a faulty park sensor or much more likely the vision gantry Y axis is not reaching the sensor. Possible issues, one of the two VY drivers cards is failing; one of the VY forcer motors (air bearings) is failing; to much air leakin
Electronics Forum | Tue Dec 09 11:40:38 EST 2008 | dwl
Hello, I have an MPM AP 25 and the camera parks itself over the worknest, so when the z tower tries to rise to print, it collides with the camera. Is there some way to adjust the park position so that the camera in not in the way of the Z tower? Than
Electronics Forum | Mon Sep 21 12:15:55 EDT 2009 | swag
Can anyone tell me the correct DIP settings and jumper positions for a MpM AP25HiE Z-axis driver card? Thanks-
Electronics Forum | Fri Oct 09 06:53:10 EDT 2009 | taus
Hello, I've recently started to work with MPM AP25, I began doing maintenance to get to know the machine. But now I'm having some problems in the teaching process. You can see the problem in the photo. http://img59.imageshack.us/i/image194p.jpg/
Electronics Forum | Sat Aug 04 08:09:03 EDT 2007 | rich7799
I found the problem... the vx cable trunking was the wrong radius, so when the axis was moving at slower speeds to read pre stop position, the axis was not reading the platen correctly due to extra downward force.. Ive now replaced the trunking and
Electronics Forum | Fri Jul 27 09:28:35 EDT 2007 | rich7799
I have Mpm ap25hie, s/w ver 7.1a The problem I have is that the machine works fine until I teach or use the pre board stop function. As soon as I use this the machine will not load the pcb to the centre of the work nest. I can manually change boardst
Electronics Forum | Tue Mar 28 19:28:54 EDT 2017 | aemery
Giao, These style of MPM's use stepper motors, but no feedback like an encoder or a resolver. In other words all axis positions are assumed after "Reset" of the machine. Because of this style of drive system there is the potential for the vision ga
