Electronics Forum | Wed Dec 06 23:54:24 EST 2006 | valuems
Think you will find every mpm is operating on dos base software, just in the last 2 years have they got software with windows base. The mouse is related to the version of software, and the old software requires only one model of mouse. Give up tryi
Electronics Forum | Thu Oct 03 18:00:51 EDT 2019 | ddfreeze
Got a used mpm up2000. It gives z axis hardware limit warning when trying to teach vision. The board raises to camera then drops back down. However when loading a board for tooling, the board stays raised up. The z table can be manually raised up n d
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Thu Jun 22 03:27:08 EDT 2006 | dman97
Hi everyone, I was wondering if anyone knew of a backdoor setting in these machines that will allow you to change the machine configuration. At my company, we have one operator who decided it would be nice to lock everyone out of the user menus. He
Electronics Forum | Thu Jun 22 10:22:28 EDT 2006 | PWH
I've done this stuff on UP3000's and AP's so hopefully my advice will help with your 2000... You can get into all upper level user modes, correct? You don't mention test, cal. or field service mode. If you can't get into those, I can send you a pr
Electronics Forum | Tue Dec 17 08:55:52 EST 2002 | Randy Villeneuve
Grant, The board maybe the problem but how is your oven working? Is it a convection oven and how many zones (top and bottom)? What does your profile look like? If you are unsure and if you only have one oven, send your board to Soltec or Electrovert
Electronics Forum | Sun Dec 08 22:20:39 EST 2002 | grantp
Hi, We have been manufacturing a PCB, however it's been quite tricky to profile, as the edges of the PCB are reflowing before the center of the PCB. I have looked at the design, and there is a small power plane for 2.5 Volt in the center of the PCB
Electronics Forum | Mon Dec 16 10:05:29 EST 2002 | Grant Petty
Hi, Thanks for the info. We are reflowing the boards, but just barely. Sometimes we get the QFP in the middle of the copper area not reflowing, and it's pain. The joints are dry, and I am not sure if it's caused by lack of heat, or the flux going ba
Electronics Forum | Mon Dec 09 09:54:16 EST 2002 | davef
Large copper pours create an unbalanced lay-up that is bad design practice, creating problems in fabrication and assembly. The hatching a previous poster mentioned could be an alternative. Stepping back a bit and wondering, what's the problem? You
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
