Electronics Forum | Fri Feb 03 12:25:34 EST 2012 | cyber_wolf
The camera is probably clipping the top of your board when it is reading fids. This causes the motor to lose steps. Manually load a board to vision height and drive the camera over the board to check for clearance issues.
Electronics Forum | Thu Jun 08 16:33:47 EDT 2017 | sumote
This may not be a solution to your problem, but something from my tuner car days jumped into my head. If you are running at 100% and not getting the height you need, change out one (or both) of your pulleys. A bigger pulley at the motor side, or a sm
Electronics Forum | Tue Aug 04 09:02:34 EDT 2009 | kpm135
We replaced the tactile sensor's linear actuator on a MPM Ultraprint 2000 HiE. Now we are getting a Tactile Hardware limit error every time we try to find the stencil height. I was hoping some one could explain why we're getting this error and any i
Electronics Forum | Wed Apr 24 13:49:19 EDT 2019 | griinder
I have a support question concerning setting the gridlock tooling in manual mode on a MPM Momentum Elite. I am printing the top side (bottom is populated with parts) of a thin, flimsy PCB. The Grid lock tooling bows the PCB upwards in Auto mode, beca
Electronics Forum | Mon Jul 26 21:56:53 EDT 2004 | pdeuel
The camera is not driven from the motor cards. The camera is attached to what is called a forcer. For the Y axis there are two of them. One is wired backwards from the other. one of the forcers is connected to a flex chanell for the air and electrica
Electronics Forum | Tue Jun 01 18:06:36 EDT 2004 | Rob
I used an Ultraprint 2000 so if that's what you use then maybe I might be able to help. First, I'm assuming that you've already passed the Teach New Board section. This is board dimension, X and Y boardstop, stencil/squeegee heights and strokes. If
Electronics Forum | Sat Sep 26 03:21:58 EDT 2015 | aemery
Mervin, Love these machines, Speedline built about 3500 of them so I have lots to fix. Most issues come down to incorrect use or poor adjustment and alignment. Your description is a little vague, you didn't mention which direction the prints are of
Electronics Forum | Fri Mar 23 14:13:20 EST 2001 | mnaddra
RW, I have Screened Adhesive on to several different assemblies and have found that when it is possible I get a much better result than with a dot deposition process (The green strength was greatly improved), the biggest issue I ran in to was the pr
Electronics Forum | Wed Jul 27 09:58:05 EDT 2011 | davef
Pressure printing systems Conventional stencil printing techniques have fundamental limitations as regards paste handling: The volume of paste available for printing is limited, so frequent replenishment is necessary Paste is difficult to c
| 1 |
