Electronics Forum | Tue Jan 04 15:50:23 EST 2022 | spoiltforchoice
Yeah, this won't be a hard drive space issue. More likely to be a memory issue or a virus or a corrupted system file. It could equally be a faulty piece of hardware and a misleading error. For instance on Windows NT, at least according to this site h
Electronics Forum | Tue Feb 21 08:12:11 EST 2012 | vparis
Hey I am in need of the following replaclment parts for an MPM SPM-AV s/n: 7095 Im looking for the Z-Axis Motor MPM p/n: 000298 and a Z axis belt MPM p/n: p2387 Let me know if you have any of these or you can shoot me in the right direction.
Electronics Forum | Sat Mar 28 12:25:48 EDT 2009 | gpaelmo
We have an MPM SPM-AV screen printer and we need to replace the Z-axis timing belt. P/N of timing belt is P2387. Anyone know what the length is does not specify in manual? And instructions on how to remove and replace it? No mention in MPM maintenan
Electronics Forum | Fri May 27 14:24:18 EDT 2005 | james
We are currently having problems with our SPM AV Screen printer. It is an intermitant problem, sometimes it will make a loud noise as the stencil is going down on top of the board and sometimes it does not meet its destination. Sometimes the machi
Electronics Forum | Fri May 27 16:27:14 EDT 2005 | cmiller
Could be a lot of things but try this, on the SPM that we have the lead screw that moves the blades up and down runs through a piece of threaded plastic. When it strips out, it starts to cause all kinds of wierd problems. The replacement part we got
Electronics Forum | Wed Jun 08 09:37:20 EDT 2005 | james
Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I
Electronics Forum | Wed Jun 08 12:04:34 EDT 2005 | james
Ok here I go again. I got rid of the last problem but now I am back to a different problem. When the machine sits and I press Reset, the screen reads Starting the Z-axis Homing the Programmable squeeges and just stays there and does nothing. So I E-s
Electronics Forum | Mon May 30 00:11:47 EDT 2005 | vms
Hello James and Michelle Have been reading this thread and I just have to add my 2 cents. I was under the impression that this site was created with the idea of a place to post a problem and see if some one else may be able to help with a answer. I
Electronics Forum | Wed Dec 14 09:46:48 EST 2016 | westshoredesign
So recently I attempted to do the trackball upgrade for our MPM SPM printer, the touchscreen was unable to calibrate correctly. Unfortunately upon reboot after installing the software the PC wont boot into MS-DOS. It's still functional, as I can brow
Electronics Forum | Sun May 29 21:44:20 EDT 2005 | KEN
This from a person named "just my thoughts"? As far as "cheaper in the long run" , that can be debatable. Especially at $160 dollars per hour for a FSE. Double rate for weekends. Air fare, hotel, car and per-diem....it adds up fast! Also, he may
winsouce.jpg)