Electronics Forum | Thu May 12 13:31:54 EDT 2016 | walbright
We are talking about an IC in a TO263 package.
Electronics Forum | Thu May 12 13:26:31 EDT 2016 | kahrpr
Hi Are we talking about a BGA or a resistor. Knowing the type of part would help.
Electronics Forum | Thu May 12 10:49:27 EDT 2016 | Bill Albright
If an electronic component with a MSL rating of 1 is exposed to an moist environment greater than the 85% relative humidity to the point where the packaging is wet, what is the risk level of using the device in a lead-free soldering reflow process?
Electronics Forum | Fri May 13 17:28:43 EDT 2016 | dyoungquist
Depends a little on how long it was exposed to the wet environment as moisture absorption by electrical components is a very slow process. That said, MSL 1 rated components can be exposed to high humidity indefinitely and still not need to be baked.
Electronics Forum | Thu May 12 14:15:50 EDT 2016 | kahrpr
This is just me but I would just let it air dry. If you think about it. If you were using water soluble paste you would run it through a washer and it would survive. If this was a BGA i would be very concerned. If you are truly worried look an the ma
Electronics Forum | Fri Jun 16 08:37:51 EDT 2006 | Chunks
What type and brand of fluxer?
Electronics Forum | Thu Jun 15 22:17:02 EDT 2006 | Thanagon
I'm now have target to flux saving. Could you please tell me. If we adjust level of spray fluxer nozzle up then we can saving cost of flux Quantity usage? What Others must adjust? such as pressure , flux flow. Thank you All for advise.
Electronics Forum | Wed Sep 27 08:28:05 EDT 2006 | AR
Hi all All you wave soldering people, have you had any trouble in keeping the copper level of your SAC solder pots under control? How do you combat the gradual rise of copper contents owing to dissolution from through-hole component leads etc.?
Electronics Forum | Wed Sep 27 10:02:24 EDT 2006 | aj
Hi, We are using SACX and have not noticed any rise in copper. I do know that there are Solder Bars available without the Copper to try and bring the level under control. aj...
