Electronics Forum | Wed Jan 30 08:50:55 EST 2008 | scotceltic
Best 3D system we purchased and have been running for over a year now is the Koh young. Best Gage R and R, easiest programming, easiest user interface and best defect detection. We used to run an MVP Supra in 3D but had issues with software glitche
Electronics Forum | Mon Nov 08 15:50:45 EST 2021 | jdengler
Nick, I don't have a MVP but our Mirtec does odd things when the hard drive gets over about 90% full. It will hang up at various tasks and sometimes just abort the program. Maybe the MVP is similar. Jerry
Electronics Forum | Tue Apr 16 09:58:10 EDT 2019 | ttheis
Resolved; the power box "service" switch was set to ON. Changed to OFF and machine powered up per instructions. Didn't see this switch mentioned anywhere in the power up procedure. Thanks to the previous owner for tipping me off.
Electronics Forum | Tue Nov 09 04:28:23 EST 2021 | ttheis
Don't know much about them, we have one for sale cheap if interested; located in midwest.
Electronics Forum | Tue Apr 16 09:46:36 EDT 2019 | ttheis
We just bought a MVP Supra M machine and have put it under power but can not get the PC system to power on. I am following the power up procedure in the manual. Under power the conveyor controls work and the UPS backup turns on, but holding the key i
Electronics Forum | Tue Aug 19 20:44:38 EDT 2008 | fede
Hello Gentlemen. Looking for an AOI for my company�s high-mix mid-level production SMT lines; I�ve investigated almost all suppliers. I also read several posts in this forum. I live in Argentina, so it�s very difficult for us to visit their facilit
Electronics Forum | Tue Aug 17 11:44:19 EDT 2004 | rlackey
Hi, does anyone have any real experience in using the following AOI systems (including opinions on support)? Cyberoptics Flex Agilent SJ50 MVP Supra Landrex Optima (Teradyne) Please fight the urge to pass comment or point out the error of my ways i
Electronics Forum | Tue Feb 14 04:40:47 EST 2006 | Rob
Pete's advice is spot on - you need to do this. We did roughly the same thing, and the known defect board caught a few out - especially one manufacturer that lowered all of the fault thresholds to pass the previous defect free boards (we didn't tell
Electronics Forum | Mon Nov 08 14:45:19 EST 2021 | nparo
Greetings, I have an AOI machine that I am programming however I have ran into an issue with the board grab function. I an creating a new program and the screen should show the camera image and allow me to grab the board corners and create the image
| 1 |
