Electronics Forum | Wed Dec 27 09:05:35 EST 2017 | charliedci
All the response is appreciated. We have 4 SS machines and 2 operators (normally). Some jobs take up to 15 minutes (multiple boards), some take less than 2 minutes (machine time). Some involve fixtures, preheat, some may require the operator to mon
Electronics Forum | Tue Sep 12 11:55:30 EDT 2000 | Mike F
In general I agree with Dave and Chris, but some parts have leads that can't be clinched (connectors, some header sticks, etc.). If the problem part has not been a floater in the past, then check the lead finish and your flux application. A bad finis
Electronics Forum | Wed Dec 05 03:33:22 EST 2007 | longlee
We have done Paste-In-Hole process for 4 years.I think this prcess is suitable for 28-pins connector. Of course, you must assure the connecotr can endure high temperature firstly.Secondly, you need calculate the volume of solder paste, you can refere
Electronics Forum | Fri Apr 15 10:47:09 EDT 2005 | patrickbruneel
Dhanish, If I understand correct your ICT doesn't detect shorts and only measures capacitive and resistive values. The webbing as Ken mentioned would have a resistance because this is caused by a lack of flux and the web is mainly tin oxide, which w
Electronics Forum | Wed May 11 17:25:22 EDT 2022 | SMTA-64387687
You've replaced the sensors and cleaned any grease residue inside the Midas head, and you're still getting this error. You can check the connector on the little board, on top of the Midas, where the flex cable plugs in. I don't remember, off the t
Electronics Forum | Thu Mar 26 08:51:40 EDT 2009 | avalancher
Hi Sr. First suggestion is to call Mydata's phone support. With that said... Here is some ideas of what you could check: 1. Do you have power at the XWB board connector going to the motor (xxwm connector)? 2. Do you have power coming through the bl
Electronics Forum | Fri Apr 01 01:26:17 EST 2005 | Marv
A couple of things.. 1) The problem is more than likely on the magazine board itself (TC2), most likely the pal chip that stores the serial number and feeder information (you could swap this with a working magazine to verify) 2) The magazine connecto
Electronics Forum | Mon Jun 19 22:19:40 EDT 2006 | Nathan
Dear All, We plan to setup an assembly line for our small volume production of PCBs (about couple hundred PCBs per week). The board has about 150 components (less than 30 types) and a few BGA and IC (majority is SMT, only few THT connectors). We hav
| 1 |
winsouce.jpg)
.gif)
