Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Thu Jul 18 00:08:31 EDT 2019 | mk15
hank you for the tips. MOT boards have already changed. The sensor on the conveyor responds. In service mode, the WIDTH MOTOR - OK, HOLD MOTOR - OK, SET CONVEYOR - OK, only error TRANSPORT - F-MOT-MSETDYN conveyor transport / 1250: amplifier DC-link
Electronics Forum | Thu Aug 13 14:43:23 EDT 2015 | alphatronique
HI i try to figure how the "Manual load adapter" work on a T3 Table machine ? seem that the table always try to move the board to the the left sensor location ,but if i use the magnet manual table it will never find the board on the table convey
Electronics Forum | Wed Jul 17 02:31:30 EDT 2019 | mk15
I am looking for some help for where to look to fix this MY15E problem.After hardware initiation appear F-MOT-MSETDYN conveyor transport/1250: amplifier DC-link too high.Any suggestions? Thanks
Electronics Forum | Wed Jul 17 17:56:38 EDT 2019 | rgduval
Check the MOT board. You can usually swap out the individual MOT boards, and see if the problem moves. If it does, you can isolate which board has gone bad. You can also check the encoder on the conveyor, to make sure that is still working correct
Electronics Forum | Mon Apr 24 04:23:56 EDT 2006 | TA
Hello guys, I am Looking for a oven with the following specifications. Can any one suggest me the best suitable model. Thanks ========================================================== - heating length 2500mm - zone top/bottom 7 - forced convection
Electronics Forum | Wed Jul 19 20:24:41 EDT 2023 | ttheis
Conveyors are connected to machines with SMEMA cable interfaces; any edge conveyor manufacturer will have this interface.
Electronics Forum | Tue Jan 17 16:12:39 EST 2006 | ronhammer
Does anyone have any experience with a MyData Tray Wagon Magazine (TWM)? If so what do you do behind it for a conveyer? We received a TWM to test and it will not work with our conveyor system. MyData said to change to a different set of adjusting hol
Electronics Forum | Tue Nov 10 09:45:52 EST 1998 | Scott McKee
| We are currently in the process of purchasing a new low volume SMT line. Based on our research, Quad and Mydata seems to best fit our applications. Has anyone used both equipment and experience the pro and cons of each machine? Thanks in advance fo
Electronics Forum | Tue Mar 31 15:14:53 EDT 2009 | kpm135
Is your machine an inline system with the conveyors along the back? If so I have run into this problem before with the sensors on the covers for the conveyors. They are 'magnetic' safety switches that can appear to be closed but don't actually switch
