Electronics Forum | Tue Dec 05 09:59:24 EST 2006 | sigmasmt
This is for CP6 feeders? What is the smallest componet run on this machine(0402,0603)?
Electronics Forum | Tue Dec 05 13:18:29 EST 2006 | sigmasmt
Let me rephrase my question. Tom, What is the smallest componet you are running on your machine?
Electronics Forum | Wed Mar 06 20:46:31 EST 2024 | erikfriesen
Does anyone else calibrate Samsung CP feeders? I've done a handful here on my machine, I wonder what the proper way to do this is. Set the rear stop first, then the front notch point? They seem to need to be together, but its a bit cumbersome to g
Electronics Forum | Wed Dec 20 22:54:28 EST 2006 | fastek
I think that in this day and age.....if you are not testing the feeder via some sort of indexing proceedure while the feeder is off of the machine.....you are simply not going to be certain the feeder is working properly. The Alternative SMT jig do
Electronics Forum | Thu Mar 20 14:58:04 EDT 2014 | aybars
We use IQ feeders from PPM and cant find any > reference material on maintenance and calibration > of these feeders. Does anyone here know where I > can get repair manuals, diagrams, or any info on > these feeders at all? Hi guts1782, IQ feed
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Electronics Forum | Fri Feb 11 15:50:51 EST 2005 | Grant
Hi, We are looking at selling the machine in mid April, May time frame. We are selling the machine, all feeders etc. But it's located in Australia, so a bit hard to ship to most locations. If your interested, please email grantpetty@blackmagic-desig
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Mon Nov 12 12:00:59 EST 2007 | wayne123
A philips Topaz is a good machine, I have accurately placed 0402's without a problem, Fine pitch QFP no problem, BGA's not a problem, I am not familiar with the TP9 so hopefully the other guy can answere questions on that, The Topaz is rated at about
Electronics Forum | Mon Nov 12 13:35:34 EST 2007 | dyoungquist
MyData TP9s Work well in high mix applications because change over time from 1 job to the next can be done in as little as 15 minutes if you have the right mix of magazines/feeders. Component placement rates vary depending on which component you ar
