Electronics Forum | Thu Feb 13 00:43:06 EST 2014 | brendansales
Centering motor about to fail or has failed. > Centering motor about to fail or has failed. Hey Rdubya, Thanks for your help! Apparently that was not the problem. The Midas head had to be all the way down below the lower locking solenoid. After
Electronics Forum | Wed Feb 19 09:52:45 EST 2014 | brendansales
Dear Rob, Got to the maintenance menu, under the Motor section, I selected Z motor and tried to initiate motor, there was no movement on the machine and I had the error message as below: F-MOT-MSETDYN Z/12: Position counter dead I suspect that ser
Electronics Forum | Sat Jan 29 04:59:02 EST 2005 | Grant
Hi, MYDATA's are ok for lower volume, and they are very flexible. If you only have 1 or 2 trays of components and are on a tight budget, then you can even place the trays on the Y wagon behind the PCB so you can get away without the tray wagon. Al
Electronics Forum | Tue Feb 03 15:28:36 EST 2009 | kpm135
I agree, I'd try placing them with the midas or z-fi head depending what you have. Try using the mechanical centering in the zero angle with a low strength to move it straight. You'll probably have better luck finding a tool that will work on the hea
Electronics Forum | Tue Dec 21 12:28:11 EST 2021 | vtdivtecs
hey all, I had a comically bad failure yesterday while working with my pick and place, a part got dropped at exactly the wrong moment and flung a bracket up into the tool path, severely damaging the hydra controlboard that is next to the x camera. T
Electronics Forum | Fri Jan 05 16:16:51 EST 2024 | mistrthou
Based on the my15 we used to have and our current My100's I'd say it lost the position of the tool bank. Is it Hydra or Midas tooling? Uninstalling and reinstalling the hydra tool bank is fairly easy. If it's Midas tools, does it fetch other tools
Electronics Forum | Thu Nov 15 23:45:53 EST 2012 | jaimebc
robgd3, The Z motor can be purchased separately, however, the theta motor can't. You need to buy the whole midas head. I didn't get as far as dissembling the theta motor casing to get to the theta motor. That was my worse case scenario. We ran thou
Electronics Forum | Mon May 09 19:00:47 EDT 2022 | SMTA-64387687
Z-force sensor is a tool travel indicator. It has nothing to do with Z travel. Does the Midas head move at all, during initiation? It sounds to me like a Z motor/encoder problem. Is the Midas head ribbon cable plugged in?
Electronics Forum | Sat Nov 20 12:10:37 EST 2021 | bk
Yes, you can run tm magazines on my machines but with the hydra heads they are not quite as accurate and miss pick more parts then agilis feeders. Mycronics does sell dual head machines with 2 midas heads and 2 sets of hydras
Electronics Forum | Tue Aug 09 23:27:24 EDT 2005 | grantp
Hi, I think there are two models of HYDRA, and is it for both? We exchanged the MY9 we had for a MY12, and they said it had a newer model of HYDRA that was easer to align, and maintain, and I wonder if that was part of it, or if this is still an iss
winsouce.jpg)