Electronics Forum | Fri Nov 30 00:14:36 EST 2007 | vinitverma
ET, With due regards to your '7 years experience', I must say that in my 11 years experience, this is the first time I am hearing about head replacement on a Topaz. On the Eclipse it is easy for an operator to make a mistake by moving the head manua
Electronics Forum | Sat May 29 14:03:18 EDT 2010 | padawanlinuxero
Hello guys! I have a problem I had to change the MI Board on a MYDATA TP9-4 machine because it was firing 3 or more feeders at the same time, after the change it run great but then for some reason after a while it start to show an error message that
Electronics Forum | Tue Oct 23 00:52:16 EDT 2018 | filipblad
Yes, for all tools... The tool head stops just above the tool
Electronics Forum | Tue Oct 30 12:03:32 EDT 2018 | cambriadj
It is always an enticing thing to watch high speed machines planting parts lickity split. We are a small shop doing experimental and short runs, and have been running our dear old Mydata TP9-2U for years. No repairs, never failed because we have alwa
Electronics Forum | Tue May 07 16:19:47 EDT 2013 | dyoungquist
The "25v reads 3V" part of the error message may be your clue. Since the machine runs for a while and then shuts down, something may be failing after it warms up. "F-AXIS-182:C-AXIS NOT properly out when expected" refers to the centering jaws not o
Electronics Forum | Wed Jan 02 12:15:44 EST 2002 | pteerink
Don't waste your money on T&R feeders for large parts. I used to have an old TP9 and we ran tons of products with vibe tubes and odd shaped parts. Used to cut our own tubes for parts and jimmy-rig parts like crazy to make them all fit on the machine
Electronics Forum | Tue Mar 31 11:41:50 EDT 2009 | klelectronics
I receive this message everytime I turn on my machine " Release Emergency Stop Button." I checke all every loction and stop button. Cant find out the problem. Does any one have a solution to this?
Electronics Forum | Fri Nov 02 22:30:04 EDT 2018 | ecdave
Hello. Hoping to find help troubleshooting z axis issue. Initializes OK, and runs a bit sometimes not going all the way down to reach feeder, misses part and tries again, usually successfully, before ultimately stopping for "F-MOT-MOVE INDVACWAIT Z/2
Electronics Forum | Thu Jul 18 17:38:27 EDT 2019 | rgduval
Not swapping out feeders....swapping out magazines. It only works well if you have enough extra mags to load all the feeders on. And is a viable solution if your position limited on your machine. Before the advent of Aegis feeders for My machine
Electronics Forum | Thu Mar 10 23:23:56 EST 2005 | pmd
We have a MyData TP-9-2 with a in line Y wagon. It is a long screw and the vintage is 1994. The Y wagon vibrates at about 24 micrometers at about 25 hertz. Burnin reviels zero encoder pulse errors. Hystersis test indicates a Y axis Y wise varance of
