Electronics Forum | Wed Jun 09 23:58:59 EDT 2021 | SMTA-64387687
The electrical test, on those older machines, wasn't very exact. Try to expand the tolerances, 25-30% for caps and 10% for resistors, and see if that solves your problem. Also, if I remember correctly, if you go into the layout and single-place the c
Electronics Forum | Thu Jun 10 16:40:48 EDT 2021 | cyber_wolf
Yes those verifiers seem like a good idea but they really don't work correctly. You would be better off verifying with a meter during reel changes than wasting your life on that thing. I concur that single mount will show the value.
Electronics Forum | Tue Jun 08 22:30:05 EDT 2021 | vtdivtecs
So I am having a little trouble with my mydata MY19. its an older machine picked up used and its had its quirks. recently we tried to start adding electrical verification to our workflow, and had to disable it as we were getting intermittent bad pa
Electronics Forum | Thu Jun 10 17:22:10 EDT 2021 | vtdivtecs
thanks! definitly not the answer I wanted to get, but it's good to hear it. Back when we sourced the machine a few years ago I was kinda against buying it as our production scale is so small it doesn't add a ton of value, BUT the electrical verific
Electronics Forum | Fri Mar 27 12:46:23 EDT 2020 | unisoft
Unisoft has been import gerber only for years to setup assembly, aoi machines, etc. *** Help for Importing GERBER only files for used in programming Assembly, AOI, Test, Selective Soldering machines (X/Y Center, Rot, Part#). Also allows you to cre
Electronics Forum | Thu Jul 27 16:54:46 EDT 2006 | pjc
In-Circuit test, or ICT, is the most common method of electrical test for an assembled PCB. It is the most comprehensive and accurate method to ensure that both the PWB and components are working to specification. Not all components however can be el
Electronics Forum | Fri Jan 19 05:46:59 EST 2018 | ivammendes
MYDATA MY9E: Hydra's pipe can't stop the vacuum during assembly. The problem ocurre just in only one pipe, the number 5. The tool picks components but doesn't drop it. Can the problem be in the unit vacuum?
Electronics Forum | Mon Feb 26 12:26:43 EST 2001 | CAM
I'm working a problem and looking for your input. Here the deal: Two sided mix technology board. Test is using unmasked via points on bottom for test points. Our fab drawing states tent via points on top side. First set of board came in with no tenti
Electronics Forum | Wed Dec 23 15:35:18 EST 2015 | taborheiking
So I'm in Maintenance and I've been getting a lot of component feeder magazines back that have faulty circuit boards etc and I was wondering if there was anyone out there who has made a desk top test fixture for any of the Agilis or TMD Magazines or
Electronics Forum | Thu Feb 23 17:50:53 EST 2012 | burb1999
Trying to electrical test some transistors SOT-23, SOT323, SC70 and keep getting the no value obatined? What would cause this everything seems correct in all the part data, etc. In the parameters we have the option :) pnp: mechanical phase (2) leve
