Electronics Forum | Thu Feb 20 13:25:18 EST 2014 | brendansales
Dear Rob, Thank you for your quick response! There were Z locks on the Midas head area, 2 little solenoids like you mentioned. Previously I had the first error code (F-AXIS-C/9) and after fiddling around, randomly manual unlock the Z locks it came
Electronics Forum | Thu Nov 18 00:28:02 EST 1999 | Scott McKee
Use Mydata. I've built huge backplane boards, round boards, 1/4" thick boards, 1"X24" boards, 1"X1" boards, L-shapes boards; all without any carriers or tooling. If you buy a MY15 you can increase the board size to 5'X2' (60"X24")... As for ovens,
Electronics Forum | Tue Jun 14 15:59:25 EDT 2022 | mikevb
Thanks! I just needed a response like that. I will do all that, and if it's still an issue, I'll change the x wagon encoder right? There are three encoders on the x wagon though? The white one on the x carriage, the white one on the x belt drive mo
Electronics Forum | Wed Jun 15 19:46:15 EDT 2022 | mikevb
Hey All. I figured it out. It turns out that the problem was simply a loose coupler on the x wagon motor transducer. I had only checked one screw in the past but the other screw was apparently loose as well.
Electronics Forum | Sun Jun 12 01:44:59 EDT 2022 | mikevb
I forgot to mention that I've measured and adjusted the cog play on the x axis and so it is within range, if that applies.
Electronics Forum | Sun Jun 12 01:38:47 EDT 2022 | mikevb
I'm having a problem with my Mydata My9 pick and place. Basically whenever I try to run the placement calibration program or try to have the machine find fiducials, or basically anything with precision, the machine displays a X MOT motor timeout erro
Electronics Forum | Mon Oct 31 02:38:18 EDT 2011 | kenmar
Hi Phil, Thanks I will contact Mydata to see about a possible software upgrade.
Electronics Forum | Sat Oct 29 12:53:34 EDT 2011 | dontfeedphils
We had the same motor problem with our My12, whenever we would get the sound we would go through and slow down X accel speed in any packages and the placement accuracy as well. After doing this for quite a while we finally tried updating the motor c
Electronics Forum | Tue Jun 14 15:02:13 EDT 2022 | glasscake
Start with fundamentals: Disconnect, clean and reconnect all inner connections, bulk heads, ext. Disconnect, reconnect all connections at the controller. Check wiring harness for conductivity. Clean everything appropriately, lube ways, balls screws
Electronics Forum | Tue Jun 14 16:23:22 EDT 2022 | glasscake
Cant put a finger on it being an encoder that was just a single possibility. You can always hook up a scope to the encoder and see if they are working appropriately. I would look through the machine's utilities and see if there is some debug or more
winsouce.jpg)