Electronics Forum | Wed Dec 12 15:00:43 EST 2007 | mefunak
Hi,everybody! There is an interesting things happened with the 0402 components- machine Siemens HF3,it's an Emergency Stop error message " Component not at nozzle before placement" and there is a chance to find an extra components lying in a mess on
Electronics Forum | Thu Dec 13 10:39:38 EST 2007 | lloyd
Hi Mefunak, I'd say that the vacuum holding circuit is at fault. If the component is picked OK from the feeder ('vacuum check after pickup' is switched on) then the component is being dropped from the head as the gantry moves to the placement positi
Electronics Forum | Thu Dec 13 16:22:15 EST 2007 | mefunak
Thank you,LLOYD,for your response,all your prepositions will be checked. And about switching machine on and off, I absolutely agree with you, it's the perfect cure for Siemens))) But,a strange thing happened,we changed a head,that started to make the
Electronics Forum | Tue Jun 09 14:10:41 EDT 2015 | duchoang
Last time I used Topaz X2 was 5 years ago. Correct me if I'm wrong. There are some reasons: -Head dirty so machine thought there was nozzle on head already. -Nozzle changer/ Nozzle position offset. -Something jammed and nozzle changer can not go all
Electronics Forum | Wed Jun 10 00:34:40 EDT 2015 | vinitverma
I understand from your post that the head does go to the nozzle changer intending to change the nozzle but sometimes it entirely fails to pick up the nozzle and sometimes the nozzle gets picked up a bit but gets stuck in the nozzle changer. This mos
Electronics Forum | Tue Jun 09 04:49:12 EDT 2015 | vinitverma
Is the machine not picking up nozzle from the nozzle changer or is the head 7 not picking up any components? Or is the mis-pick rate too high?
Electronics Forum | Tue Jun 09 09:04:58 EDT 2015 | lisaaci
Its not picking up the nozzle from the changer. It either doesn't at all, or leaves the nozzle partially in the changer.
Electronics Forum | Tue May 12 17:01:27 EDT 2015 | lisaaci
Our Philips Topaz is not picking up any nozzles on head 7, or only partially picking it up. Previously, the machine had thrown up a message that head/nozzle 7 needed cleaning, but that message doesn't appear anymore. I don't know if the head needs cl
Electronics Forum | Wed Jun 10 01:33:20 EDT 2015 | leeg
Are the leaf springs in good order and set right? If they are then it could be calibration related.
Electronics Forum | Wed Jun 10 01:35:07 EDT 2015 | leeg
Does head 7 calibrate ok? Is it a bent shaft?
