Electronics Forum | Tue Nov 01 16:16:59 EDT 2016 | sbuettner9
I am looking at replacing our Technical Devices Nu/Era JR 10" wave solder machine. I have looked into the Technical Devices CV400 which is in our price range but want a couple other comparable units. Our target price is between 30-40K. Does anyone
Electronics Forum | Fri Mar 03 08:00:49 EST 2006 | paulinct
Hi Everyone, I am in the process of selcting a new wave solder machine for our small company. We currently run 2 Technical Devices (18" Nu Era Jr. dual wave). I considered converting one to Lead free. It seems for alittle more we could have a machin
Electronics Forum | Thu Mar 31 12:23:53 EST 2005 | jdumont
We are looking into purchasing a new NuEra model. What model/vintage do you have and how have your experiences been with it? Thanks JD
Electronics Forum | Wed May 27 07:53:41 EDT 2009 | padawanlinuxero
Thanks ! I will try your recommendations, about the flux and the preheaters, yes they seems to be ok I will bring down de conveyor speed because it looks like if it is to fast is set to 3.6ft thanks again!
Electronics Forum | Wed May 27 11:54:29 EDT 2009 | allwave
Armando, Make sure chip wave is pumping evenly across. These TD machines require a lot of maintenance (deep cleaning)to ensure all the holes on nozzle are open... My two cents, George
Electronics Forum | Fri May 29 02:08:08 EDT 2009 | cobar
Check that you are getting an even spray pattern from the fluxer.Check that the chip wave nozzle is clean and if possible feed the PCB in to the wavesolder unit at 90 � or 180�.
Electronics Forum | Thu Dec 09 16:15:32 EST 2004 | Kevin
You should try looking into the Technical Devices Nu/Era. They offer the best warranty on their lead free solder pots. They use something called Titanium Nitride which has been tested to outlast Melanite. The dross produced on the TDC machines i
Electronics Forum | Wed Jan 02 15:13:49 EST 2008 | allwave
Hi everybody, I am looking for an alternate source of wave solder fingers for our machines Technical Devices Nu/Era. Does anybody know of some other supplier? I tried the ones from JAFCO but did not perform to our expectations. Any help on this wi
Electronics Forum | Wed Mar 15 13:00:08 EST 2006 | jdumont
Hi Paul, I have been to the Novastar mfg plant in Penn. and to a demo of the TD Nu Era model also in Penn at Advanced Competitiveness Institute. After seeing both we have decided to go with the TD model. Im not sure where you are located but the regi
Electronics Forum | Tue May 26 06:56:40 EDT 2009 | xinxi
Hi! From your post, it seem like the wave did not really touch the component. You probably need to get the both wave height correct and that it hits the component.It is normal for solder to come through the PCB when using chip wave. The through-hole
winsouce.jpg)