Electronics Forum | Thu Aug 11 10:21:40 EDT 2005 | leonb
HI all, i have 2 omniflow 5 zone reflow ovens would these be suitable for rohs compliance also 2 iemme 760 reflow oven with 4 upper zone and 4 lower zones would these be suitable also any feed back would really help
Electronics Forum | Thu Aug 11 16:20:54 EDT 2005 | pjc
I have seen good results on OmniFlo 5 for Pb Free solderpastes PROVIDED the boards are low to medium thermal mass and have no high conveyor speed (high production) requirements. Max peak temp you can set on O5 is 280C, enough to get 230C on-board tem
Electronics Forum | Mon Apr 29 01:29:29 EDT 2013 | aemery
If your current problem with the conveyor speed was caused by the SMEMA issue, maybe you have a Board #1 problem. The SMEMA communicates to the computer through Board #1. The input signal from the speed encoder and the output analog voltage to the
Electronics Forum | Tue Nov 14 11:43:49 EST 2017 | matthale
Does anyone know of a good servicing company for Omniflow reflow ovens? Preferably in the north of the UK. The chain rails on ours have warped and need straightening. While the oven is still usable without, it is by no means ideal.
Electronics Forum | Wed Nov 15 07:04:11 EST 2017 | spoiltforchoice
Short of the obvious choice of Etek-Europe as the UK representative, not really. They also retain quite a few sales& engineering people form Contax who did it before them. There seems to have quite a collection of small companies in the UK that servi
Electronics Forum | Wed Feb 23 18:27:12 EST 2005 | gpaelmo
Hi Indy, Check http://www.jmw-inc.com (they are in the midwest so shipping will not be too bad going out east). I bought 2 MPM printers and a pick and place machine from them late in 2004. I know they have 5-zone reflow and 7-zone ovens there (elect
Electronics Forum | Mon Mar 27 11:24:59 EST 2006 | mac
Had similar issue with Omniflow. Was actually jostling tall electrolytic caps off of pads. Found that idler sprockets/pulleys needed lubed.
Electronics Forum | Wed Sep 25 16:01:17 EDT 2013 | action_101
We have the thermal connections on our omniflow, but we prefer to use the mole. I actually prefer the kic profiler over the mole profiler, but you work with what you have sometimes. The benefit of using an external system is you don't have the long t
Electronics Forum | Tue May 07 09:42:17 EDT 2013 | cyber_wolf
We bought a "very used" Omniflow 10 at least ten years ago. We have only replaced maybe 5 blowers in that time.
Electronics Forum | Mon Jan 15 15:18:13 EST 2007 | jaimebc
We have an oMniflow 7 as well, and looking at the calibration procedure, it indicates that turning the pots ( total of 5 pots. 4 on the lower board and one on the upper board )fully counter-clockwise is the FIRST step of a series of tests. Then you w
