Electronics Forum | Mon Aug 30 20:32:37 EDT 2010 | davef
So let's see, Cost of Ownership = [[Equipment cost + Setup]+[Operating costs]] / [Yield*Throughput*Utilization], where 'Operating costs' include: chemicals, water, electricity, DI tanks, filters, recycling costs, etc.
Electronics Forum | Tue Nov 18 08:50:15 EST 2014 | cbeneat
All of your maintenance costs, grease, filters etc. on a scheduled basis.
Electronics Forum | Mon Sep 27 21:08:11 EDT 2004 | davef
Danny: Beyond the US$40k that you mention for the machine, how much money should be budgeted for: * Facilities cost for spray room contruction, venting / filtration, fire proofing, etc? * Operating costs, such as training, maintenance, operation, et
Electronics Forum | Tue Nov 18 11:41:02 EST 2014 | jimmyboz
Tools, installation rigging, and training.
Electronics Forum | Mon Sep 18 20:24:25 EDT 2000 | Dave F
What are the non-recurring operating costs of running this machine? How long does it take to program a rework operation, assuming you have CircuitCAM or something like that?
Electronics Forum | Thu Jun 28 15:00:45 EDT 2007 | gdzuber
Hello Everyone, I am wondering what you are paying for Nitrogen (N2) in for your re-flow or wave, in $ per m3/hr. Please get back to me so I can determine some long term operational costs. Best regards, Gary Z.
Electronics Forum | Fri Mar 05 06:59:31 EST 2004 | t_white
We use a SAWA to clean our stencils and it performs quite well on solder paste but not so great with epoxy. Operators find the machine very easy to use and like mentioned before it takes up minimal space and has a lower intial and operating cost.
Electronics Forum | Tue Jul 08 16:00:04 EDT 2014 | comatose
The boards are expensive because they are your product... covered in circuitry. A 2% scrap rate costs twice as much as a 1% scrap rate. Say the parts on your consumer electronics board cost $5. A machine that makes 99% good boards and 1% bad boards
Electronics Forum | Mon Nov 17 16:23:14 EST 2014 | budro
The company I work for is installing a SMT prototype line, and I've been asked to determine the cost of operation. I know there will be cost for solder, solder paste, flux, stencils, glue, nitrogen, ect... I just want to make sure I'm not missing any
Electronics Forum | Thu Jun 10 10:52:22 EDT 2004 | drlou
Jon, This is good stuff! Thanks. Lou
.gif)
