Electronics Forum | Wed Jan 21 16:55:22 EST 2004 | patrickbruneel
Hi, Are you testing bare boards or soldered boards. Are the test probes in contact with soldered pads or contacting the copper with the osp coating (not soldered). If you could clarify this it would be easier to give some hints for probable causes.
Electronics Forum | Wed Jan 21 17:43:04 EST 2004 | Kris
Hi, I had the same question. In our case we are contacting the copper with the osp coating (not soldered). any published reports that we can reference Thanks
Electronics Forum | Tue Sep 26 08:41:27 EDT 2000 | greg
I am processing PCB's that have an n-tech osp coating and am finding huge inconsistencies in wetting. Some boards process clean with good wetting and the next has terrible wetting. The boards are stored and handled properly. Has anyone had this
Electronics Forum | Wed Oct 01 10:57:53 EDT 2008 | blnorman
Oxford Instruments makes a device called the OSPrey 800 that measures OSP thickness on the pads. We took a look at it last year because we have one line that uses OSP. It is pricey, and that's why we didn't order one, but if you use a lot of OSP, m
Electronics Forum | Mon Sep 29 16:02:33 EDT 2008 | scottd3
We are having problems with a specific lot of boards wave soldering. I need a way to prove the boards are bad, does anyone know a way to verify the amount of OSP coating on a board, or a company I can get to do it for me? I am using PBfree solder of
Electronics Forum | Tue Mar 10 22:16:56 EST 1998 | Steve Gregory
Jeremy, I'm gonna make a couple of assumptions by "reading in between the lines" of your email: 1. You're using no-clean paste. 2. This is only happening on the second side. You tell me if I'm wrong about this... First thing, if you're only experienc
Electronics Forum | Mon Sep 29 17:31:39 EDT 2008 | davef
Q1.Does anyone know a way to verify the amount of OSP coating on a board? A1. There is no specification. Thickness is difficult to measure. Thickness is product related. There are at least six major suppliers. Years ago, here on SMTnet, J Medernach s
Electronics Forum | Thu Sep 10 20:46:05 EDT 2020 | SMTA-64387687
Has anyone had experience in applying OSP coating? How difficult is the process? And, what is the equipment used?
Electronics Forum | Mon Oct 09 10:58:26 EDT 2006 | Matt Smith
Over the past several months we have experienced intermittent problems with wave solder voids on PCBs coated with OSP. We suspect variation in the OSP application process, or oxidation of the surface due to insufficient or degraded OSP. Is there a me
Electronics Forum | Wed Jun 26 13:56:01 EDT 2019 | SMTA-John
We are considering storing OSP coated PCBs in nitrogen. Will this extend OSP life ? Is the eventual failure of OSP due to oxygen eventually reaching the copper over time ?