Electronics Forum | Wed Jan 21 05:01:10 EST 2004 | sd
Does anyone have any reports on OSP pcb finish and ICT Testing? Having a problem with contact issues.
Electronics Forum | Wed Jan 21 09:36:52 EST 2004 | davef
As with noclean flux, OSP will fill your probes with crunchy [maybe gummy] stuff. Consider: * Increasing frequency of probe maintenance * Talking to your probe supplier about alternate probes that self-clean better
Electronics Forum | Wed Jan 21 16:55:22 EST 2004 | patrickbruneel
Hi, Are you testing bare boards or soldered boards. Are the test probes in contact with soldered pads or contacting the copper with the osp coating (not soldered). If you could clarify this it would be easier to give some hints for probable causes.
Electronics Forum | Wed Jan 21 17:43:04 EST 2004 | Kris
Hi, I had the same question. In our case we are contacting the copper with the osp coating (not soldered). any published reports that we can reference Thanks
Electronics Forum | Thu Jan 22 08:48:42 EST 2004 | patrickbruneel
Kris, You will need to change your probes to "bite" into the surface twisting probes specialy designed for copper surfaces. The surface hardness of copper is a lot higher compared to tin. link to article from osp manufacturer (see page 5) http://www
Electronics Forum | Thu Jan 22 09:21:45 EST 2004 | davef
Oh, another thing, we do not like to probe copper. It's hard, compared to solder, and beats-up the probes too much. [As Patrick Bruneel states in this thread.] Consider reflowing paste on your test pads.
Electronics Forum | Wed Oct 06 04:11:35 EDT 2010 | grahamcooper22
I've done minimal research to this point and > understand my issue with solder on the double > sided boards is due to oxidation that occures on > the unpopulated pads when the board makes its > first trip through the reflow oven. > > We did run
Electronics Forum | Thu Oct 07 15:50:57 EDT 2010 | boardhouse
Craig & Rem - I would also recomend switching to ENig - OSP would be my sencond choise ENig will give you the flatness your looking for plus the best shelf life. Enig is about 5% more than Hot Air. Enig also does not cause as much stress on the c
Electronics Forum | Fri Jul 02 17:10:43 EDT 2004 | blnorman
We looked into OSP for lead free. OSP is less costly than ENGI.
