Electronics Forum | Thu Oct 04 21:39:44 EDT 2012 | jeffr
Are you saying that the buttons on the Joystick work, but the Joystick lever for XY is not working?
Electronics Forum | Wed Sep 19 06:42:56 EDT 2012 | ekki511
Hello alltogether we have some old assembleon mashines here in hungary. Since some days we are fighting with our Eclipse. After started if we push the ready button appear the error code : L006:Tr.over current. Does anyone know what is Tr. ? Is this
Electronics Forum | Thu Sep 20 21:58:39 EDT 2012 | jeffr
4 connectors because the pins push back ! 2/.. Check mechanical freedom of each axis. With power off.. feel each motor rotation for a burnt armature. 3/.. Replace the Driver Board.
Electronics Forum | Thu Oct 04 17:02:40 EDT 2012 | ekki511
Hallo Jeff thanks a lot for your answer. Yes the error was the bad driverboard. The daughterboard AC . We changed and the mashine is running. Unfortunately we have now a problem with the Handheldkeyboard.The joystick is not working. The same problem
Electronics Forum | Wed Sep 27 16:54:30 EDT 2000 | LarryK
We currently use Kapton tape to cover a display. The only real purpose for this tape is to cosmetically protect it thoughout the process. The display gets hand soldered and washed, so the idea of the tape being high temperture isn't a factor. Becaus
Electronics Forum | Fri Feb 15 08:33:59 EST 2002 | fmonette
The joint IPC/JEDEC standard currently specifies a limit of one bake cycle, regardless of the temprature or duration. In the proposed revision this will be replaced by a maximum cumulative duration of 48 hours at 125C. The reason identified for thi
Electronics Forum | Wed Aug 31 00:50:59 EDT 2005 | grantp
Hi, We have a new part we need to mount, and it's a .5 mm pitch BGA with .3 mm diameter pads. That's a lot smaller than we have done before, and we currently use 1 mm pitch BGA's with .5 pads. Has anyone does .5 mm pitch BGA's and what needs to be
Electronics Forum | Fri Feb 22 08:14:22 EST 2013 | markhoch
We've had a lot of turnover with our operators, so currently we do a complete 1st article inspection before sending any PCBs in to the Reflow Oven. So our first PCB in the oven is the 1st PCB of the new job. (after it's been inspected).
Electronics Forum | Sat Mar 08 21:45:59 EST 2003 | MA/NY DDave
Hi The other thing the Ni does is to create a time barrier for the underlying copper (Cu) migration into the joint. Degradation still occurs yet it is slowed significantly. Diffusion Equations under, electonic current pressures across time, are inv
Electronics Forum | Mon Jan 29 11:14:44 EST 2001 | medernach
Hi all, Here's the deal. I have a customer for whom I assemble a lot of product. All of their product mix goes through a water soluble process. Much of it gets conformal coated. They are in the high power arena but some products are simply contro
