Electronics Forum | Mon Apr 19 01:36:55 EDT 2010 | jola
Been a while since I used those machines but I found a list on how it was on ours anyway: MV2-F,C: F8-F1-F7-SHIFT-M-V MPA-V: F8-F1-F7-SHIFT-M-P-SHIFT-A-SHIFT-V MPA-G1: F8-F4-F7-SHIFT-M-F7-P-F7-SHIFT-A-F7 Always start from the main "run" screen. Go
Electronics Forum | Fri May 24 07:53:13 EDT 2024 | davidk
In our company we are facing the problem at our SMT line with component: relay panasonic TX2SA-5V.... Very frequently there are missing or lifted components(chips or small SOT) nearby of theses relays after reflow. Did someone faced to simmilar issue
Electronics Forum | Wed May 29 02:01:10 EDT 2024 | kumarb
No direct experience with these parts but to me, the air flow from top side fans are creating a wind tunnel that is causing the smaller parts to fly. Can you adjust the speed of these fans? Review the paste - review the component mount height. We fac
Electronics Forum | Wed May 29 07:41:33 EDT 2024 | tommy_magyar
We use the same component on many different products, never faced a similar issue. However, things I would check are: - stencil thickness (ideally 125um) - additional Z move on the parts around the relay (as suggested by kumarb) - check the packages
Electronics Forum | Thu Dec 30 14:40:05 EST 1999 | Sergio Luiz Vito
I am Looking for used dispenser machine manufactured by panasonic (HDP-G1 or HDP-G3). Thanks Eng. Sergio Luiz Vito
Electronics Forum | Thu Dec 30 22:01:33 EST 1999 | Dave F
Sergio: You're looking on all the wrong places. Go to: * SMTnet PCBCE Mart * chipshooters.com * ipc.org * Any of the myrid of equipment brokers listed in the archives * Panasonic Good luck Dave F
Electronics Forum | Wed Jan 15 12:38:23 EST 2003 | welsh
Hello Anybody ever had trouble with the Screen on their HDP, it is constantly dark (you can just about see the characters) its an LCD screen not a CRT, Any Ideas?
Electronics Forum | Wed Aug 23 22:31:06 EDT 2006 | Derek
I have an ongoing problem with a Panasonic HDP3. When the machine is switched on, the screens flicker for a while and then it eventually starts the boot up sequence, but resets itself. Each time it starts the boot up sequence it gets a bit further. A
Electronics Forum | Tue Apr 07 12:35:22 EDT 1998 | Ron Beasley
Any one have any experience with or knowledge of the Panasonic HDP-G1 adhesive dispenser, or any other Panasonic dispensers.
Electronics Forum | Wed Jun 20 10:43:59 EDT 2012 | dharbin
Looking for a theta servo motor. Panasonic part # MFG10DALM5BJ. Panasonic can't supply and I have checked several 3rd party sources.
.gif)
